Which thickness is best for inflatable waterpark ? Do different material have different roles in parts of a project? Like sealing or flanges or holder hanging materials or anything else? Or we can make a complete project with one single thickness??
@DIYPackraft
6 жыл бұрын
The material you use should depend on the strength required for the particular application. For testing you can order a sample pack with all of the different fabrics.
@Cimmeron
4 жыл бұрын
Hi Matt Have these instructions changed for the v3? In the written instructions the 3L piece is fixed to the floor on both sides Should I be following these videos or the protected v3 instructions?
@DIYPackraft
4 жыл бұрын
Hi Sean, you’re is a V3 Kit so please follow the V3 instructions. I’ll change the titles here to make it clearer that these are the old V2 instructions. Cheers!
@findingnimo4707
6 жыл бұрын
What type of thread is used for stiching inflatables? And do we need heat sealing even after stching..whats more reliable ? Or Can we do both of them togather?
@DIYPackraft
6 жыл бұрын
You can do both if you want, but heat sealed joints are stronger than the fabric itself, so sewing would not add any strength.
@findingnimo4707
6 жыл бұрын
Ok which method is stronger hot welding or sewing?
@findingnimo4707
6 жыл бұрын
For adult water park
@OneWayTraffic
6 жыл бұрын
Once a seam is stronger than the fabric itself, no point in adding extra strength. I'd bet that welding is stronger.
@mishrasunny
7 жыл бұрын
In this video, you are using an Iron with Red Handle and a smaller Tip (assuming: Mini Iron II). I was testing this iron (Heat Setting: High) on your 40D Heat Sealable Nylon-66 Fabric. As soon as I touched the fabric with the Iron, the test fabrics melted and got stuck to the Iron tip. Do you use a different heat settings for different grades of your fabric? Also, how do I remove bits of fabric from the iron tip? Can I simply use some paint thinner or nail polish remover? Thnx
@DIYPackraft
7 жыл бұрын
Hi Sunny, there is some variation between iron temperatures, even among irons of the same model, and you may find that the medium setting works better for you. Please check www.diypackraft.com/proper-heat-sealing-technique/ to learn about setting the right temperature. To clean your iron, you can rub it on some wood while it is hot to remove the melted plastic. There may be some dark residue left, but this will not affect the iron's performance.
Пікірлер: 12