Super cool, wanting to make a broken pirate ship for Halloween too. Thanks for the ideas-
@ambersutherland5408
Ай бұрын
Your welcome! It was a lot of fun
@tiffani602
6 ай бұрын
LOVE THIS! I'm going to attempt to make one this year, thanks for all the measurements and details, hoping mine turns out just as good.
@ambersutherland5408
5 ай бұрын
It was so fun! I’d love to see a picture when you’re done!
@anubis520
29 күн бұрын
This looks good. I was going to make one for halloween this year and this def gives me some confidence
@ambersutherland5408
10 күн бұрын
It was so much fun! Good luck 😀
@kushcraft9914
Жыл бұрын
That was really Kool. 👍 Great job !
@katiew578
Жыл бұрын
Great JOB!!!! I love it!!!! Im going to have to try to make one!!! Thank you for the video~!!... I hope you make more I enjoy watching them
@alexledezma7629
8 күн бұрын
Another question, how do you have the ship leaning upward (as if the ship were sinking? Was it just stabilized with that chair? Lastly, what were the measurements of the scrap plywood used for the front of the ship? Im taking notes!
@ambersutherland5408
5 күн бұрын
Yeah we tied it to the chair to hold it up. We didn’t actually measure the front pieces out just used our leftovers so I’m not quite sure the measurements on those
@yvonnem1919
Ай бұрын
Looks great ! How did you make the Kraken legs?
@ambersutherland5408
10 күн бұрын
We used dryer vent hose with PVS pipes inside to hold the shape and cut pool noodles for the suction cups.
@therewolf8137
6 ай бұрын
How well did the waterproofed Masonite (hardboard) hold up in the weather?
@ambersutherland5408
6 ай бұрын
It held up great, way better than we expected. We live in lots of wind and snow so we gave it two full coats on both sides. No signs of water damage and it was outside for about a month.
@alexledezma7629
4 ай бұрын
Where did you buy the masonite hardboard tiles?
@ambersutherland5408
2 ай бұрын
From a local lumber yard, they didn’t have anything at any of the big chains
@CTRCustomWoodworks
10 ай бұрын
Looks amazing! How tall is it after it’s done? Just trying to figure out how tall the U shaped pieces are, thanks.
@ambersutherland5408
10 ай бұрын
We did it at 4 feet
@CTRCustomWoodworks
10 ай бұрын
@@ambersutherland5408 awesome, thanks. I took a screen shot and measured, and got 40”, lol. Close enough. Thanks for the video, super helpful!
Пікірлер: 19