For written step by step instructions, visit: www.instructables.com/id/Multi-Purpose-Plywood-Robot-Prototyping-Base
This video will guide you through the process of testing the plywood robot base made in the Part 1 of this video: • Multipurpose Plywood R...
You will only require an Arduino (UNO or Nano) and some jumper cables.
______________________________
Connections are as per the following:
Arduino Vcc -------- Battery +ve terminal
Arduino 5v --------- Pin 1, 9, 16 of motor driver IC
Arduino Gnd -------- Pin 4, 5, 12, 13 of IC & Battery -ve terminal
Arduino Digital pin 5 ------- Pin 2 of IC
Arduino Digital pin 6 ------- Pin 7 of IC
Arduino Digital pin 9 ------- Pin 10 of IC
Arduino Digital pin 10 ----- Pin 15 of IC
Then you will have to upload the code below to your arduino:
////////////////////
void setup()
{
pinMode(5, OUTPUT);
pinMode(6, OUTPUT);
pinMode(9, OUTPUT);
pinMode(10, OUTPUT);
delay(3000);
}
void loop()
{
digitalWrite(5, HIGH);
digitalWrite(9, HIGH);
delay(3000);
digitalWrite(5, LOW);
digitalWrite(9, LOW);
digitalWrite(5, HIGH);
digitalWrite(10, HIGH);
delay(2000);
digitalWrite(5, LOW);
digitalWrite(10, LOW);
digitalWrite(6, HIGH);
digitalWrite(9, HIGH);
delay(2000);
digitalWrite(6, LOW);
digitalWrite(9, LOW);
digitalWrite(6, HIGH);
digitalWrite(10, HIGH);
delay(3000);
digitalWrite(6, LOW);
digitalWrite(10, LOW);
delay(3000);
}
////////////////////
_____________________________________
Please follow me on my instructables profile: www.instructables.com/member/S...
My blog: sirkitstudio.blogspot.in
For any assistance, you can drop a comment below or contact me personally at agrawalsanyam946@gmail.com
I can even provide you the pdf file will detailed instructions if you want.
Don't forget to subscribe for more cool projects!
Негізгі бет Ғылым және технология DIY Plywood Robot Base: Testing (With a Simple Arduino Project)
Пікірлер: 1