This video discusses how to make the bypass loop needed when removing the power steering system from a 1989-1995 Toyota Pickup (or 2nd Gen 4Runner). Please refer to my other videos for further information regarding driving the Toyota Pickup with vs. without power steering.
The flaring tool I use to create the double flare is the Rigid 345 manual flare tool (make sure to get the dies for doing the double flare, not just the single flare only):
www.ridgid.com...
NOTE: the tool is expensive and is for inch sizes, but will clamp down with some force to hold the 10mm tubing size fine with some force (you'll need to lightly press the tubing back to round once finished). Practice first on some extra tubing, because you only get one chance at this. Make sure the ends of the tubing are clean and square before flaring / hold the tool in a vice while working; make sure to clean any burs from inside the tubing before installation. Also make sure the ends are exactly the same length and leave enough extra room (length) so you can get the tool on the tubing with the nuts installed.
Негізгі бет DIY Power Steering bypass loop for Toyota 22RE Pickup 4Runner 89-95 P/S removal
No video
Пікірлер: 5