Welcome to Part 3 of my Tamiya Audi Quattro A2 Body Set Build and detailing guide. Today I am testing my setup of 3 volt LEDs before finally installing them into the body. I want to run the LEDs straight off the main RC battery, with 2 headlights, six spotlights and 2 rear lights. First I have to work out how to wire them up safely, so I make a test rig - let there be light!
The component I used were as follows:
3mm and 5mm 3 volt LEDs, forward voltage = 3v and forward current = 20mA, Light Beam Angle = 30 Degrees
220 Ohm 0.25 Watt metal film resistors
The Tamiya battery plug, connector and switch were stolen from an old Tamiya MSC (Mechanical Speed Controller)
Thanks for watching! :))
Негізгі бет Автокөліктер мен көлік құралдары DIY RC LED Install - Tamiya Audi Quattro A2 Body Detailing Pt 3
Пікірлер: 98