Good job like Always. But one thing is good to be mentioned. That step up or down circuit can get very hot. Using Hot glue to place it there is not good idea. It will fall off and move easily. Other than that the work is very clean
very nice but better if you make the collar holding the led adjustable in order to adjust your light from flood to more focus
@ozanoloji1
Жыл бұрын
Hello. Is fan cooler required for xhp90?
@GiauDIY
Жыл бұрын
i don't know because i don't use xhp90
@ozanoloji1
Жыл бұрын
@@GiauDIY 10w power 3.3Amp size 9*9mm Do you think 40*40 aluminum cooler will be enough?
@GiauDIY
Жыл бұрын
@@ozanoloji1 I think you should look for bigger aluminum
@warsitoanomwijaya5760
9 ай бұрын
Itu memakai pipa ukuran berapa inchi
@wowyummyyy
2 жыл бұрын
❤️👍❤️ ❤️👍❤️ ❤️👍❤️ ❤️👍❤️ ❤️👍❤️
@be4885
Жыл бұрын
xhp70.2 can use 12v you may not need step up and step down you just need 5w,10w,20w and 1-10ohm ceramic resistors
@GiauDIY
Жыл бұрын
thank you for sharing
@CV-zl7zo
Жыл бұрын
its for the cv cc or led will fry with to much current
@be4885
Жыл бұрын
@@CV-zl7zo using convoy xhp70.2 driver
@ilhamprakoso3844
Жыл бұрын
@@CV-zl7zo theres some overcurrent protection on bms, just use bms with same specs with led.
@sunartabanten7786
Жыл бұрын
Itu kaca nama nya apa
@gztr
2 жыл бұрын
Good job good product But you didnt share any explanation, which part do you use... Which part and which power did you use for it. I know some, you use bms and power led but what ıs the middle part from bms to led? why do you use it? Is ıt led driver?
Пікірлер: 18