Thank you for watching! If you have any tools you would like for me to review please leave a comment. thank you!
@YouCanMakeThisToo
4 жыл бұрын
Great overview! Looks like a good piece of kit. If you rotate the miter the other direction so the point of the miter is against the fence, the flip stop should work. Great video work, the shallower depth of field was nice and colors looked better 👍
@foxhallww311
4 жыл бұрын
YouCanMakeThisToo true. But that is scary cut though. Maybe just be me.
@JohntheSchreiner
4 жыл бұрын
Looks handy. Might be a good option for me since my used saw didn't come with one!
@foxhallww311
4 жыл бұрын
John the Schreiner go for it. Apparently amazon is out of stock right now though.
@stevesiefken6432
3 жыл бұрын
Great review! Thinking of getting one. I didn’t understand your con about the stop bar not being wide enough. It seems like it sticks out pretty far. Thanks!
@foxhallww311
3 жыл бұрын
Hey Steve. Check out 3:10 of the video. The flip stop isn’t long enough to butt up the end point of a miter joint.
@stevesiefken6432
3 жыл бұрын
@@foxhallww311 Ahh! Gotcha, thanks! Keep the videos coming👍🏻
@David-hm9ic
3 жыл бұрын
That plastic screw that holds the lens in place is your friend. If you broke it, you were seriously over-tightening it. It takes very little pressure to secure the lens. Had it been a steel screw, you most likely would have broken the lens attachment point.
@foxhallww311
3 жыл бұрын
Probably was defective. It broke in the production stop for the kreg stop kit.
@tomalealso
2 жыл бұрын
I have been looking for a better miter gauge, It looks like is is well made but I doubt I will get it. honestly for the money, having a drop in pin to hold the angle is ridiculous, it might be ok for a 30 dollar gauge but certainly not at the price point of this tool. I am sure that it works well, but I will loose that pin in the first 10 minutes in in the shop. what happens if It gets knocked around and the pin comes out without me knowing it, then I am on my hands and knees looking for the silly thing. dumb move.
@foxhallww311
2 жыл бұрын
no doubt! the pin is my biggest hang up with it. I have lost it several times and it's currently lost at the moment. I got the Incra 1000HD That I am about to do a review for once I get my shop back into working order
@TheFalconJetDriver
4 жыл бұрын
I was curious about the cost of this miter gauge, to compare it the Incra 1000HD that I have. Your video must be working it is not available right now on Amazon. 😁🛫
@foxhallww311
4 жыл бұрын
TheFalconJetDriver I bought it for $139. I think it’s $149 right now.
@foxhallww311
4 жыл бұрын
That’s funny. It was available yesterday. They just have just ran out.
@mikecarlin3396
3 жыл бұрын
Will this work on a Milwaukee table saw 2736-20?
@foxhallww311
3 жыл бұрын
I’m pretty sure it will? I know the table saw the little bit smaller. The miter slot should be the same size for all saws
Пікірлер: 17