Today we build the vanity cabinet for my uncle and aunt's bathroom remodel. Watch from start to finish how Tom gets it done and shows you how you can build one too.
Stuff I Used:
3/4" Maple Plywood ( for box sides and bottom 1 sheet)
1/4" Maple Plywood (for door panels and drawer bottoms 1 sheet)
1x4x 3/4 (for rails, stiles and face frames 4 - 8' pieces)
12 - 20" drawer glides
4 soft close hinges
Gray spray paint and Kilz primer
Wood Glue: amzn.to/2E8ePfg
Drawer Glides: amzn.to/2SJFirJ
Soft Close Hinges: amzn.to/2BALf07
Brad Nailer: amzn.to/2TOcnQi
Kreg pocket hole jig: amzn.to/2GlfqfO
Kreg drawer glide jig: amzn.to/2BzjSn7
Kreg hinge jig: amzn.to/2E83dc5
Kreg drawer pull jig: amzn.to/2UVYMXC
Kreg clamp: amzn.to/2Glgz76
Kreg pocket hole screws: amzn.to/2N4Vv5t
Delta Hybrid Table Saw: amzn.to/2IoMbLd
Craftsman Professional Miter Saw: amzn.to/2N4TS7Q
___
DONT FORGET TO LIKE COMMENT AND SUBSCRIBE.
Subscribe: / @maker-logic
___
ADD ME ON:
Facebook: / darlingwoodworking
Subscribe: / @maker-logic
Twitter: / jtomdarling
Ebay Store:
www.ebay.com/s...
Website: www.teamworklog...
___
Thanks for watching! -Tom Darling
MAKER LOGIC
Негізгі бет DIY Traditional Vanity Cabinet Build
Пікірлер: 214