It's 'spooky' season! And we are so excited to share this fun DIY with you! We want to introduce you to Pacific Mold Design who has made this DIY possible. Be sure to check them out so you too can get your very own molds. We hope you enjoy this DIY and have a great Halloween!
Rapid Set Products:
- Concrete Leveler: www.ctscement....
- Mortar Mix: www.ctscement....
- Flow Control: www.ctscement....
Concrete Mold Supplies:
- Skull molds: / @pacificmolddesign
- PAM cooking spray
Mixing Supplies:
- Small hand drill
- Gloves, mask & protective eyewear
- Mixing bucket or bowl
- Concrete sealer (optional)
- Clean cool water
- Rit Dye (optional) www.ritdye.com...
Small skull & plant holder skull:
- Spray inside mold evenly with PAM (don't use too much)
- Prepare 2 QT Concrete Leveler in bowl
- Grab 12 oz of cold water
- Mix in half the water, mix, then add the rest of the water as you mix
- Mix until it is a pancake batter consistency
- Add Rit Dye (optional) for color and mix evenly
- Pour into molds
- Tap sides lightly
- No need to water cure since Concrete Leveler is self-curing
- Demold after 2-3 hours
- Take out of the mold in 4 hours
- If desired, use a concrete sealer
Large Skull:
- Spray inside mold evenly with PAM (don't use too much)
- Prepare 2.3 QT Mortar Mix in bowl
- Mix 1 TBS of FLOW Control to Mortar Mix
- Grab 14 oz of cold water
- Mix in half the water, mix, then add the rest of the water as you mix
- Mix until it is a pancake batter consistency
- Add Rit Dye (optional) for color and mix evenly
- Pour into the mold
- Tap sides to release air bubbles
- Start water curing with cold water once the material has lost it's moist sheen on top
- Keep water curing so that the material doesn't get too hot or else this could lead to cracking
- Demold after 1 hour
- If desired, use a concrete sealer
Decorate & enjoy!
www.ctscement.com
Contact us for more information at info@ctscement.com
OR 800-929-3030.
Негізгі бет DIY your own Skulls this Halloween with Rapid Set!
Пікірлер