00:10 Rear seat modification
The rear seat should be removed because we want to install a 4-point seat belt.
00:43 Fabrication of roll cage
Originally, the pipe was a little thinner, but we dared to make it thicker because it would not stand out after completion.
02:18 Making the floor mat
The fur was too long. We should have used a finer-grained powder.
06:03 Finishing the floor
I change the atmosphere from floor mats. I used fine grass powder used in model railroad dioramas. Most people use flocking powder, but 1/12 requires a lot of it. Powders for model railroading are convenient because they come in large quantities. It is also inexpensive.
06:57 Making and installing the foot panel
This is the part that will be hidden in the shadow after completion. I wanted to install something that glows a little, so I made it.
08:42 Making seat belt
This is TAKATA's 4-point seatbelt. This is fun work.
10:53 Installing everything.
The racing seat can be installed in the same way as the real car.
It might have been better to put them a little further back.
Негізгі бет Do the interior. Shelby GT500 1/12 #15
Пікірлер: 41