It's titled "baker rebuilds dodge charger sxt first start and drive!". Thanks for checking out my content!
@FiveO
3 жыл бұрын
Man you have come along way!!! That’s so awesome you are building engines!! Keep the videos coming!
@bakerRebuilds
3 жыл бұрын
Thanks brother! Ive been enjoying it,, I'll do my best!
@PCMastersrt8
3 жыл бұрын
Beautiful and amazing work! thanks for sharing keep it up Man! Greetings from Mexico.
@bakerRebuilds
3 жыл бұрын
Thank you! I really appreciate that 🙏
@BeverageHunters
2 жыл бұрын
Im gonna be working on my 06 charger. Hope its just the head gaskets. But could be full rebuild
@bakerRebuilds
2 жыл бұрын
Well hopefully it is just a head gasket. I would suggest a leak down test and compression test before dismantling anything. More information the better. Good luck!
@jeffreyrivera9459
11 ай бұрын
How serious is it if something like a pebble fell into the oil entryway of this type of engine, I hear a clink up against the top manifold but doesn’t bounce around it’s just on cold start. As if it doesn’t travel anywhere and it just stays in the top
@bakerRebuilds
11 ай бұрын
Not great. Could be fine or might be a matter of time before a spring, valve, cam lobe gets damaged. I can't recall if it's an interference engine but if it is, personally I'd definitely want it out. It's not too difficult to pull the valve covers. Might be worth getting it out for peace of mind.
@vsg_stangsquad7207
Жыл бұрын
I need to pick your brain on a rebuild on a 06 I just need a few confirmations
@bakerRebuilds
Жыл бұрын
Yeah, shoot
@vsg_stangsquad7207
Жыл бұрын
Ok so on the crank there is a little nipple on it that sticks out but the oil pump has to go over it. Do you have to remove that nipple or the oil pump gasket will slide over it without an issue?
@bakerRebuilds
Жыл бұрын
@@vsg_stangsquad7207 If you could go to my Instagram and send a picture, that would be helpful. I don't recall any sort of nipple. Also is this a V6 or V8?
@vsg_stangsquad7207
Жыл бұрын
Dm sent
@TheCherrybomb0824
3 жыл бұрын
very good video thanks
@bakerRebuilds
3 жыл бұрын
I'm glad you enjoyed it!
@welcome2darealr229
9 ай бұрын
were the cylinder heads already put together or did you have to assemble it yourself?
@bakerRebuilds
9 ай бұрын
For the v6, we just reused them as they were. Knowing what I know now I think it's well worth it to have a shop check for bent valves, weak springs and replace all the valve stem seals. Our v8 we had the heads gone through and it had two bent valves with about 170k miles. Bad intake valve stem seals can lead to burning oil so especially with higher mileage I'd have them gone over.
Пікірлер: 23