Thanx for video. My wife's journey needs these. 245 thou and still running well.
@workisfun...2438
Жыл бұрын
Nice. We have 220k on ours with few problems over it's life. 👍🏼. We bought it new and the dealer can't believe we haven't "retired" it.
@millermiscellaneous1771
5 жыл бұрын
Nice Video! Makes me want to go buy a Dodge Journey with bad struts.
@Tomsfoolery.
5 жыл бұрын
Aren’t you just a comedian! 🤣
@nilesthompson4069
4 жыл бұрын
I have one if your really interested!🙂
@WSRWSRWSRWSR
Жыл бұрын
Thanks Tom. I'm preparing to replace front and rear on my Dodge journey. Great videos sir!
@MDkmimic
3 жыл бұрын
Awesome hopefully this fix all my rattling I have every time I run over a bump or messed up rodes
@opera93
2 жыл бұрын
Thanks, WHAT DID YOU DO for your Vehicle/Didge Journey?? See my comments;; ***ALL NAPA stuff**, by my ***Shop. So far great, even with WINTER TIRES STUDDED , **MOUNTED….: must get new Summer Tires in April/ May…..
@JAI45624
3 жыл бұрын
I just did the same exact job, you are right the wiper Cowell is time consuming
@juanzuniga9203
2 жыл бұрын
Wish all videos were as good as yours
@ricardoperez8879
4 жыл бұрын
Great video. Thanks for the speedy tutorial
@Tomsfoolery.
4 жыл бұрын
Thanks!
@Mac4280
4 жыл бұрын
Just a tip! If you cant get the wiper arms off try spraying some wd-40 on the threads and they should slide off the bolt. Works like a charm!
@unacceptablefullsender1878
3 жыл бұрын
I propped mine up the same way to change my wiper motor when i couldn't get the one arm off.
@01dummyaccount
2 жыл бұрын
Great video! Great information and visuals
@Tomsfoolery.
2 жыл бұрын
Thank you!
@setapart3391
2 жыл бұрын
Wait till you do the rear. It's crazy
@johnthomas9391
Жыл бұрын
You don't need to remove the wipers or the plastic cowls. Unclip the lower cowl from the strut brace (Xmas tree clips along the bottom and the 4 on the front), turn the clip 1/4 turn close to the middle near the passenger side wiper (to disengage it), undo/remove the plastic "screws" and clips on the outside most corners. The you can lift the cowl up enough (it will unclip along the top). The you can unbolt the strut brace and remove it from the vehicle
@gblim398
2 жыл бұрын
Great video. Thanks.
@TEll-dm5ck
4 жыл бұрын
Great video. Clean, efficient ,right to the work. No nonsense . Thank you
@carloscedric9827
3 жыл бұрын
I realize Im kinda randomly asking but do anybody know of a good site to stream newly released series online ?
@chaimarlo9964
3 жыл бұрын
@Carlos Cedric flixportal :D
@carloscedric9827
3 жыл бұрын
@Chaim Arlo Thank you, I went there and it seems like they got a lot of movies there =) I really appreciate it!!
@chaimarlo9964
3 жыл бұрын
@Carlos Cedric you are welcome =)
@slowlydimming4320
2 жыл бұрын
Nice job
@hamzadjerbouha5820
4 жыл бұрын
Thanks a lot I did it my self
@samuelporter581
5 жыл бұрын
NOW IF I ONLY HAD A SHOP WITH ALL THE TOOLS AND LIFT!! OTHERWISE VERY INFORMATIVE, HOW ABOUT THE REAR STRUTS SAME VEHICLE AND BALL JOINTS.
@KipdoesStuff
2 жыл бұрын
just as easy to do this with a floor jack.
@JDsSportsCards_
3 жыл бұрын
Great video thank you
@martinrocha8607
3 жыл бұрын
Thank's to this video.i helped
@Nick-be5hh
2 жыл бұрын
Great video. Presumably you have to change both sides even if one hasn't failed yet ?
@kendrictaylor8091
4 жыл бұрын
Cool video I’ll be doing my own and $ave
@kainhall
2 жыл бұрын
4:30 have a buddy hold the hood ALL the way up And then have him tap it with a hammer . While you use both hands to wiggle it . . . It will pop right off Just takes 2 to 3 people lol
@souland777
2 жыл бұрын
I got a buzzing noise when the wheel is turned to right between ~5 and ~25 degrees. No sounds when turned further or to the left side so far. Especially heard at speeds faster than ~60km/h. Does that mean my struts are weared too much and I need a replacement? Thanks! Fiat Freemont 2.0MJ 125kW Manual, FrontWheel Drive.
@kainhall
2 жыл бұрын
Probably a wheel bearing or something rubbing (like the fender liner) . To check the struts Look for leaking shock oil . Then bounce the car Get 2 or 3 people, and really bounce it up and down . Then let go . . If it continues to bounce more than 2 or 3 times....they are worn . A new strut will have ZERO bounce Ya let go It goes back to normal ride height And just stops
@opera93
2 жыл бұрын
Thanks, interesting.. my Shop just done all four corners on my 2015 Journey,4 Cyl/FRONT WD: with “all NAPA / quik Struts/Shocks”…..At first 200 miles driving, much better:::also switched out my worn out, Summer NOKIAN SUV tires, TO my Studded Winter Nokian tires, expensive*** at some $1800 + , but worth it so far.. Actually, only 90,000 miles on worN JOURNEY Struts: but
@mrjonnyblaze
2 жыл бұрын
I'm about to do my wife's 4cyl. The v6 shocks and struts fit on the 4cyl correct ? I'm assuming it's the same. .however seen a comment it won't fit.
@opera93
2 жыл бұрын
@@mrjonnyblaze I quit doing most Mechanics Work, unknown ..,. I using “ trusted” Shops, & doing easy stuff myself, only…( e,g. HEATER Resitor in my 2007 Canyon, FILTERS, TAIL GATE LATCH, PCV CLEANING, SOME oil,…..)
@ChevyBoyE
8 ай бұрын
How much Would This Job Cost ?
@bleakhappy
3 жыл бұрын
No cam bolts?
@zg7271
3 жыл бұрын
Mine didn’t come with adjustable camber bolts so I had to go aftermarket so I could get a proper alignment job done.
@speterbilt
3 жыл бұрын
If the strut is put back exactly back on the why would need to an alignment?
@Tomsfoolery.
3 жыл бұрын
It will never be exactly where the old one was. Also, different parts are manufactured slightly different. The smallest amount of change that you can’t even see by looking at them, will put your alignment off. If you have ever done an alignment on an alignment machine, you would understand. I hated doing them back in my dealership days…
@speterbilt
3 жыл бұрын
@@Tomsfoolery. thank you for the respomse. I have to replace the right front, but will probably do all 4 to keep my daughter and grandbabies safer. The front is floating around and the right one is leaking
@opera93
2 жыл бұрын
@@speterbilt thanks, what did you use & Brands?. See my 2015;Journey;; all **NAPA **from my TIRE Shop…though I have heard BEST TOMUSE :: MOPAR, KYB,MOOG, Monroe etc.. ACTUALLY, I have generally used or specified MONROE MOst of my Life, always had good results ( may have slight leak in 2007 GMC CANYON Front Strut @10:years & 70000 miles (?).. unfortunately we ****relocated to HELENA Valley MT, & far away from my WARSAW INDIANA AUTO service Centers of a lifetime, so prob just buy new Fronts Struts on Canyon , ETC.
@sheridanskeenum7767
4 жыл бұрын
What did you torque your top mount bolts at
@nickburke2876
4 жыл бұрын
whats the torque specs man?! i wasted my data on this video
@danmiles1466
3 жыл бұрын
3 ugga duggas
@Drumhead2k
3 жыл бұрын
@@danmiles1466 I'm not even drinking and I can't stop laughing at this comment.
@KipdoesStuff
2 жыл бұрын
How the fuck hard is it to tighten a bolt up so it doesn't come loose? lol.
@Relevantminded
Жыл бұрын
You could do it without removing either wiper I believe
Пікірлер: 51