I purchased a low-cost valve spring compression tool, but modified it to have the bends much higher up, and I ground off the forks that allow the tool to evening compress the spring. I also added two pieces of wood to the handle This made the entire process more controlled and removing and more importantly, replacing the keepers much easier.
@darrylleigh7514
8 ай бұрын
I have done this job many many times. I prefer running it up to TDC and using compressed air to keep the valve up. Never had a valve drop.
@PacificRacer
8 ай бұрын
I just didnt want to hear my compressor turn on lol
@nemesisnta9333
6 ай бұрын
Does it matter which cylinder do you start on? And do u put each cylinder on TDC?
@PacificRacer
6 ай бұрын
You can start on any cylinder. Yes, i put each cylinder as close to TDC as i can
@nemesisnta9333
6 ай бұрын
@@PacificRacer ok and then when finished, which cylinder do you leave on TDC? Or do u adjust it to the mark on the harmonic balancer?
@PacificRacer
5 ай бұрын
@@nemesisnta9333 You dont need to leave any of them at TDC if you are just doing valve seals
Пікірлер: 7