With the way that sensor looked I thought it would be a bear to get loose. Once again, you made it look simple and will save people money showing them how to change their own. Great Video!
@EfurdGarage
2 жыл бұрын
Yea i was honestly a little shocked it didnt take more effort. Thanks Will!
@WarriorOfEden3033
Жыл бұрын
@@EfurdGarage mine is hella stuck & I sprayed it 2x now with big shot blaster
@EfurdGarage
Жыл бұрын
@@WarriorOfEden3033 get it warm and use a break over bar is about all i can think of.
@kyongyi5244
Жыл бұрын
You are the one showing the right location. I looked for it, thank you 👍
@EfurdGarage
Жыл бұрын
Your Welcome!
@b5beast611
2 жыл бұрын
That helped a lot getting under the car on that one.
@EfurdGarage
2 жыл бұрын
It did. Lucky i had it up already working on the transmission earlier 😆
@moabie
2 жыл бұрын
your actuator video helped me a lot and now i’m getting this code 😭 Is this Bank 1 Sensor 2? Also is the repair the same for a 2015 ford focus se?
@EfurdGarage
2 жыл бұрын
yes, being a 4 cylinder there is only 1 bank and sensor 2 is always downstream. i believe it should be
@athstreamsandmore
2 жыл бұрын
My downstream is stuck tight. I am trying some PB blaster over a few days and will see if that helps. Getting leverage under mine is DIFFICULT.
@EfurdGarage
2 жыл бұрын
Yes try pb blaster. But also you may have to let it run for a few minutes then try while the pipe is hot. Just be sure not to touch the pipe. Sometimes you can also tighten it less then an 1/8th of a turn then it will break loose and you can loosen it
Пікірлер: 14