To excite make your pottery drum truly stand out, follow these helpful tips from experienced artisan Daria!
P.s
For drum head skin:cat fish skin, goat skin,cow skin☺️
1.You need to buy medium thickness or thick goat skin.
The goat skin size 2 inches wide than your ceramic drum body rim diameter
Amazon available. I bought my goat skin around 20 years ago...
2.Socking in warm water 6~8 hours before you make a hole, applying over the ceramic drum body.
Than, make a hole even number over the wet goat skin for sawingwithvery thickthread. (1.5 inch each hole distance)
3.use all purpose wood glue
4.clean well before you applying the leather thread (need to be little bit more wet with wet towel).
5. When you tighten up the red plastic thread, repeat more than 3 times with pin tools. But do tighten little by little each time!check out center well from the ceramic drum body's rim!
Than use the rubber band to flats down the wet goat skin around outside of the rim before dry.if you don't, it will be hard to trim with Brad knife for finishing before applying the leather thread.
6. please use wet towel to clean after applying the leather thread.
7. Please let the leather thread wet before applying over the finished rim(easy to apply over the surface of between the cutting goat skin and ceramic surface)
#ceramic #pottery #throwing #drum #music #artfair
Негізгі бет Drum Making Full guide, step by step, truly stand out with Daria!!!
Пікірлер: 6