Where are the two oil pickup locations? I dont see any locations in the flat plate.
@rensedelouweren6208
8 ай бұрын
Hi Kyle, I’m looking for a dry sump front cover for a na pp 13b. I’m aware of chip Motorsports kit, but those are … expensive. Is there any chance you are aware or someone that has one and is willing to sell it? I would love to hear from you!! Kind regards rense
@SpeedNessRx7
Жыл бұрын
Chip is doing one last run of these. After that they will no longer be made.
@KyleMohanRacing
Жыл бұрын
Didn't know he planned to discontinue them too bad
@rotaryperfection
Жыл бұрын
For me, it sucks that I can't use these front plates. My 20b is moved back in my fd chassis and sits right behind the steering rack. The lower protrusions would hit the rack so I would have to raise my engine to fit these. Be nice if someone could just machine a wider factory style oil pump to fit within the factory housing. 1/4" wider should be enough to increase oil flow on 20b for 10k rpms when the factory starts loosing pressure at around 8.5k.
@KyleMohanRacing
Жыл бұрын
Yeah I get that. I feel like they're main purpose is for racing so under extreme loads there is no oil starvation.. It sounds like you have a nice setup already going
@rotaryperfection
Жыл бұрын
@@KyleMohanRacing Yea my set up is NA and I built it back in 2009. It's PP but I limit my rpms because of the oil flow. Engine is out right now as I have to re-engineer my intake. Old one was poorly welded by yours truly. Lol!
@djbutch123
Жыл бұрын
Is there any downside to running these other than cost?
@vadski3469
Жыл бұрын
Increased crankcase vacuum which can cause gasket/seal failures. Rob dahm suggests running a pressure regulator for this reason
Пікірлер: 9