Want to convert your Aquila (an Ender 3 V2 clone) to dual extrusion? I got you covered, bruv. I took this cheap little Aquila, swapped out the electronics, added a 2nd extruder, and installed a 2-in-2-out hot end. It's easier than you think to install, however, beware the additional maintenance and tuning.
All of the designs used in this video as well as the klipper config are available here: www.printables...
Parts used in this design:
SKR 1.4 Turbo: amzn.to/3eRRu6e
NEMA 17 Stepper: amzn.to/3BtKe8l
BMG Clone: amzn.to/3LqXEX8
Real BMG: amzn.to/3Lq3rfR
Bowden Cable: amzn.to/3Br9xrH
Chimera Clone: amzn.to/3QQ9Emk
Real Chimera: e3d-online.com...
50mm Blower: amzn.to/3xB6a0m
(Amazon links are affiliate)
Негізгі бет Dual Extrusion on a Voxelab Aquila (or Ender 3 V2... prolly)
Пікірлер: 7