Why are you using suzuki oil in a ducati?????????????
@ericvondoodleburg8388
Жыл бұрын
I almost asked the same question again!!!!
@charlycharly3727
3 жыл бұрын
Bonjour à combien serrez vous la vis de vidange en NM svp
@josephorlando7151
3 жыл бұрын
20NM
@charlycharly3727
3 жыл бұрын
@@josephorlando7151 et pour le filtre à huile ? Merci à vous
@josephorlando7151
3 жыл бұрын
@@charlycharly3727 11Nm
@charlycharly3727
3 жыл бұрын
@@josephorlando7151 merci
@kiro6947
2 жыл бұрын
@@charlycharly3727 ece que il a mis du 20w60 ?
@stefanosperona3520
2 жыл бұрын
greetings !! how much oil are you putting in(including the oil you are pouring in the filter) ? the manual says 3.7 L but everyone says it takes 3.5 L
@josephorlando7151
2 жыл бұрын
I start by adding 3.4 L, that's including the small amount of oil I pour into the filter. I start and run the engine for about 15 seconds, turn off the engine, wait 2-3 minutes and check the oil level again and add oil until the level is between the lines. I used to just add 3.7L of oil to the engine but I always tended to overfill the engine.
@stefanosperona3520
2 жыл бұрын
@@josephorlando7151 Okay thank you for the quick response , have a nice day
@sasyaharry4046
2 жыл бұрын
What is the torque wrench you are using and the torque settings?
@josephorlando7151
2 жыл бұрын
Craftsman torque wrench, 20NM or 15 ft-lbs
@WillfulThinker
2 жыл бұрын
Why did you pour oil in the filter?
@josephorlando7151
2 жыл бұрын
I was under the impression that if you pre fill the oil filter, the oil will reach the bearings faster and prevent pre mature wear. I have also read that pre filling the oil filter in not necessary.
@WillfulThinker
2 жыл бұрын
@@josephorlando7151 Okay, interesting. Thanks.
@gerardogarcia9961
2 жыл бұрын
Qué aceite ocupaste?
@josephorlando7151
2 жыл бұрын
aceite de motor totalmente sintético suzuki 10w-40
Пікірлер: 22