Hi friends !
In this video, we will replace the anther without removing the steering knuckle (SHRUS)
On some cars, it is not possible to remove the joint of equal angular velocities from the axis due to the design of the corkscrew ring, which leads to the cutting of the CV joint, or by replacing the assembly
The solution to this problem is a universal anther with a mounting cone. Suitable for any car, BMW, Mercedes, Audi, Volkswagen, Opel, Reno, Nissan, Mazda and so on.
To replace the anther on Mazda 3, you need:
Head for 13
Head for 17
Gate
Medium extension to the neck
Two hammers
Chisel
A small fitting (to make it easier to remove the tip of the ball support from the soup pot)
A sharp knife
VD 40
Nitrile gloves (resistant to chemicals)
Brake cleaner, or any cleaner that dissolves grease
Paper towels
Jack
Balloon wrench for wheel nuts
Head on 21 for wheel nuts (tightening by dynamometer)
Torque wrench
🔧 Tightening moments 🔧 :
Ball support bolt nut: 45 - 55 Nm
Bolt of attachment of the CV joint to the hub: 55 - 65 Nm
Wheel nuts: 115 - 120 Nm
Негізгі бет Dust cover replacement without removing the CV joint Universal CV joint dust cover for any car
Пікірлер: 2