Prichett canyon EJS junkyard jku fellar here. Randomly come across your video but on saving your inner hub seal..put nut on after you take the outer bearing off then pull hub inner bearing comes out with seal undamaged.
@CooperOff-Road
3 ай бұрын
Nice I’ll have to try that next time. Did I run into while you guys were on Pritchett?
@MatthewCollins-t3x
3 ай бұрын
@@CooperOff-Road Yea... You were just taking some friends into chewy hill.
@CooperOff-Road
3 ай бұрын
@@MatthewCollins-t3x ohhh we’re you with the group of three JKU’s, two burgundy and one white one?
@MatthewCollins-t3x
3 ай бұрын
Yep
@CooperOff-Road
3 ай бұрын
@@MatthewCollins-t3x ohh man that’s wicked! It was great meeting you guys, you seem like really good people, I would have loved to wheeled with you guys more so hopefully I’ll see you again on the trails! And thanks for reaching out much appreciated 🤘
@rileyarthur6557
3 ай бұрын
Well I guess its time to check my hubs, been on the to do list for a bit. thanks for the reminder!
@BackCountryWrenching
3 ай бұрын
With what you know now would you have gone with ford f350 axles instead ?
@CooperOff-Road
3 ай бұрын
That’s a good question and I can’t really say cause I’ve never built a set of junkyard axles to compare them to, but I think I still lean towards the Dynatracs even though they have been a pain.
@mattbrew11
2 ай бұрын
Do you know if a Fusion Kingpin 60 with yukon hubs is like this?
@CooperOff-Road
2 ай бұрын
@@mattbrew11 ya the hub and bearing are the same 👍
Пікірлер: 14