going from turbo m54 to m52 in my drift e46 this month ! this video is good info
@dylanlobbestael
5 ай бұрын
I’ll try to make a video explaining everything involved with the swap!
@joeypatrick6170
5 ай бұрын
About time !
@dylanlobbestael
5 ай бұрын
Sorry for the delay!
@bmwe-op4jx
5 ай бұрын
its true about the washer,nice that you sand them. My only concern is the Athena gasket quality,we had many issues , leaking coolant and oil externally due to wrong gasket thickness vs the ring
@dylanlobbestael
5 ай бұрын
it's funny you say that, because the engine had a. external coolant leak from the HG the first couple heat cycles but ended up sealing after I retorqued the studs multiple times.
@bmwe-op4jx
5 ай бұрын
@@dylanlobbestael it didnt seal,will leak again for sure
@dylanlobbestael
5 ай бұрын
@@bmwe-op4jx we will find out 😂
@MathiasDana
5 ай бұрын
Whats the reson behind the change from m54 to m52?
@Cj4yy
5 ай бұрын
One big factor is cause the m52 is a iron block instead of aluminum m54 block
@dylanlobbestael
5 ай бұрын
The M54 is a good engine if you want to keep power around 400WHP, maybe more if you only street drive it. Drifting just seemed super harsh on these engines, but I probably demanded a lot more out of it than I should've.
@user-ki8zf1rp1e
5 ай бұрын
Dope build, can't wait to start a similar project with my wagon. How high are you going to be revving it without shims? I hear conflicting info about the rev limits
@dylanlobbestael
5 ай бұрын
Thanks man. Hopefully somewhere between 7500-7800RPM. Really depends if the car makes power at that RPM.
@brendongreaves
5 ай бұрын
Hell yeah brother
@dylanlobbestael
5 ай бұрын
Cheers mate 🍻
@plugpenguin1660
5 ай бұрын
do you think wiring a switch to stock efan is necessary for stock motor
@dylanlobbestael
5 ай бұрын
I would run the stock wiring and let the ECU control it.
Пікірлер: 17