Thanks for checking out today’s video! I hope that this will help you save some money and build a safer alternative to plastic car ramps. I’ll show you how to make a much safer (and cheaper) design using construction lumber. This design also includes a rear safety block to prevent the car from rolling off the back of the ramp. This is a pretty simple build and can easily be done in one afternoon.
I’ll be adding a step-by-step tutorial to my website soon: augustpineworkshop.com
Materials:
- 3 2x10s (8ft long each)
- 1 box of 2.5” wood screws
- 1 3/8” dowel rod
Minimal Waste Cut List:
2x10 #1:
- 4 1” pieces of 2x10 (cut at a 90 degree angle)
- 2 45” pieces of 2x10 (cut at a 45 degree angle)
2x10 #2:
- 38” piece of 2x10 (cut at a 45 degree angle)
- 31” piece of 2x10 (cut at a 45 degree angle)
- 24” piece of 2x10 (cut at a 45 degree angle)
2x10 #3:
- 38” piece of 2x10 (cut at a 45 degree angle)
- 31” piece of 2x10 (cut at a 45 degree angle)
- 24” piece of 2x10 (cut at a 45 degree angle)
Please note: I am a DIYer and am not responsible for any injury that may occur with use of these car ramps. Please be safe and make sure you are on a level surface any time you use ramps!
Негізгі бет Тәжірибелік нұсқаулар және стиль Easy DIY Car Ramp | Removeable Rear Safety Block
Пікірлер: 44