Support me here: / hamradiorookie
Welcome back to the channel! Following the buzz from my duct tape antenna video, today I bring you a simplified method to create mag mount BNC connectors for your ham radio antennas. After some constructive feedback, I've discovered a more efficient approach using BNC bulkhead fittings, eliminating the need for tedious sawing. This DIY guide will walk you through the steps to achieve a solid connection, ensuring better performance from your antenna setup.
Join me in this learning journey, where I also share a useful alternative for crimping tools that will make your life easier. If you haven't checked out the duct tape antenna video yet, find the link below or in the top corner of this video. Stay tuned for my next project, the 'Flaggy' - a unique take on Yagi antennas using foil tape on fabric. As always, you'll find all the necessary links for tools and materials in the description below.
Duck Tape antenna: • How to make a 2 meter ...
Previous BNC connector: • You are connecting to ...
Tools and Materials:
Klein Pliers/Crimper: amzn.to/3ZXlhy3
Crimper: amzn.to/3Ql2SI4
Crimps: amzn.to/3QkCNsN
Magnets: amzn.to/3FmbQi8
M4 Screws: amzn.to/45EvNeC
M4 Nuts: amzn.to/3rUriyO
BNC Panel mounts: amzn.to/3M6EJmh
Wire: amzn.to/3Z8qylM
Heat shrink: amzn.to/3Er5xJL
Heat Gun: amzn.to/45YygBh
Soldering Iron: amzn.to/463xUcO
Solder: amzn.to/3Z7wviU
Flux: amzn.to/3sJT3dt
Негізгі бет Easy Magnetic BNC Connectors for Ham Radio Antennas
No video
Пікірлер: 34