Looks interesting, but what do you do in the winter. It looks like you won't have a good seal. We have citrus and have to maintain at least 40˚F during the winter months.
@bootsintheroots
5 ай бұрын
If you live in a cold climate you would need to take off the rod and have wiggle track along the sides and bottom. Clamp it down with wiggle wire.
@RL-ui8zr
Жыл бұрын
You adjusted it to go up level. What heppened when you tried to lower it back to the ground, ended up short did it?
@bootsintheroots
Жыл бұрын
No, it wont land short, if you leave enough plastic material when you cut it. You are adjusting for flex and twist in the pipe. Metal pipe would be best, but this exercise was to show it done cheaper. Thx for watching and commenting.
@sislertx
2 жыл бұрын
Im confused...how do u keep the cold out? So u just leave it on and hope the cold soesnt come in at that big open.area...or the wind doesnt tear it... Im serious...i totally get the ventilation and its a major concern as we have a lot freak hot winter days.. Also what diameter is the pole u set in the ground? And could u PLEASE SHOW HOW TO DO A A "TIE DOWN" STRING OVER THE PLASTIC?
@bootsintheroots
2 жыл бұрын
Hi there, well you have good questions. We are zone 9a so the gaps are not so critical for us. If you are in a cold winter area, I would pull out the roll-up pipe, put wiggle wire track along bottom board and seal it up all the way around until spring. Tape up any corners with the special tape made for this plastic. The vertical pipes are 3/4" EMT. I have not needed an anti-flap tie-down yet for the sides so no video yet, but I'll keep it in mind. Thx for watching! Cheers.
@erinskinner4811
2 жыл бұрын
Do u have a link to the handcrank?
@bootsintheroots
2 жыл бұрын
TIRUSS Greenhouse Ventilation Manual roll up Plastic Film Hand Crank Winch Rolling Length 300ft roll up Rolling Height 13ft www.amazon.com/dp/B07H88YRBQ/ref=cm_sw_r_apan_i_T6YBJTRTH7FD8SKYNKG4?_encoding=UTF8&psc=1
@peachtreee4649
Жыл бұрын
Thank you for this video. I've been wondering for months how the plastic stay on the roller bar. 😆
@bootsintheroots
Жыл бұрын
Thx for watching. Just remember that you may have to adjust the plastic a few times to get it to go up level and as things sag and stretch. Cheers.
@bootsintheroots
2 жыл бұрын
Crank is here. TIRUSS Greenhouse Ventilation Manual roll up Plastic Film Hand Crank Winch Rolling Length 300ft roll up Rolling Height 13ft www.amazon.com/dp/B07H88YRBQ/ref=cm_sw_r_apan_i_T6YBJTRTH7FD8SKYNKG4?_encoding=UTF8&psc=1
@derrickbrooks9396
2 жыл бұрын
Nice I like that
@bootsintheroots
2 жыл бұрын
Thanks. It's nothing fancy but cheap and it works. If you need it more rigid, as the plastic does sag a bit, use metal emt. Aluminum tubing would be ideal, but hard to find and expensive. Thx for watching and commenting!
Пікірлер: 13