Maganda talaga pag may gamit kang efficient tools. Mabilis ang trabaho.
@JRBascuguin
2 жыл бұрын
Thank u po sir
@Sam-lk6eo
Жыл бұрын
Correct me if I'm wrong ! In my time as a Builder we were taught to shoot the bottom edge of the weatherboards only. Just above the one underneath. Thats the proper way ? It's stronger and more weatherproof.
@JRBascuguin
Жыл бұрын
Yes you are right!we shoot the bottom edge of the boards with 75mm galvanised jolt head nail aswel uaing the same nail gun.sorry I did not include that process in the video. Thanks for the comments
@johnnyyadao2585
2 жыл бұрын
Awesome
@ngogzillasataram9444
2 жыл бұрын
meron yan back pad brod pag adjust parang ply n bilog
@toddnewman4530
10 ай бұрын
Do you find it has enough power to punch the nails through the linea and rab board. Having this issue with 14mm linea oblique and rab, bending the nails over. Do you rate that setup.
@JRBascuguin
10 ай бұрын
It goes through from 1st nail ro 10th nail then I have to stop few minute to get more air pressure from compressor Iam using small ecko V8 compressor.
@toddnewman4530
10 ай бұрын
@JRBascuguin cheers for that..I have probably ordered the same system. That should work pretty well for me, cheers for the knowledge
Пікірлер: 9