Nice, lot of folks dont realise the intake ring makes a lot of difference in thrust numbers. thanks for this test
@pakimetro23
Жыл бұрын
The different is amazing, the sound is way better too
@georgevprochazka5316
11 ай бұрын
I would love to see a "Full ducting" VS "Open ducting" test in the same EDF Jet
@magnusn1297
Жыл бұрын
So if I understand correctly, you went from 9kg to 18kg thrust? Just because of the added ring? I know it increases the efficiency, but I didn’t think it was 100% more effective… Great video btw
@pilot482
Жыл бұрын
Yes. I knew the ring was effective but I was shocked by how much. Proper intake ducting is extremely important whether it's a inlet ring or a full ducted intake.
@davidwatkin1484
11 ай бұрын
Pounds not kilos
@AphexTwinII
Ай бұрын
NO, you will not double your thrust with a ring, the first test was in kg and the second was in lbs. He just doesn't know it. 9kg is roughly 18lbs.
@rajkumardevershetty2015
Жыл бұрын
THANK YOU
@ivan-zo8ec
6 ай бұрын
Nice tests! Did you run any tests to monitorize the temperature of the electric motor, for example, to know how much time is it capable of performing at maximum power without reaching the limit temperature? I think this could be quite interesting to know, and also for the maximum time allowed for lower power levels
@pilot482
6 ай бұрын
I didn't do any test like that. Didn't think of doing that. It really doesn't get that hot even after a complete flight. Don't think temperature would ever be an issue on this set up.
@ivan-zo8ec
6 ай бұрын
@@pilot482 How long are usually the flights you performe, and at which power level? I have been warned that a typical problem that these ducted fans have is the temperature management, specially when performing at high power levels continuously
@pilot482
6 ай бұрын
Flights are 3:30 on 5600mah packs. Mixed power setting. I sometimes run it fast because it a lot of fun to fly the jet it's in fast. It's never hot when I land. Just warm. Also on all my higher powered fan I use heat sinks which helps a lot. They sit directly in the air flow and are very effective.
@ivan-zo8ec
6 ай бұрын
@@pilot482 Nice to hear. I wanted to do some tests with some EDFs but for another application, which I need to be able to give full power to the motors during 15 minutes, and I assume that this is not possible with regular Heat sinks, right?
@pilot482
6 ай бұрын
I am not sure. I don't have batteries capable of powering an EDF for that long.
@classic5005
Жыл бұрын
would you tell please where I can find full ducted fan test bench 50 cm
@bobadingo
Жыл бұрын
question how did you get the telemetry rpm to read out correctly on your 16 Iz?? for some reason mine only reads three decimals.
@pilot482
Жыл бұрын
I am not sure. I don't think it's reading correctly though. It's showing about half of the calculated value. I think there was a setting in the telemetry unit. If I remember right if you hook the program box to just the telemetry unit there are some setting in there. Otherwise select the rpm in the radio telemetry and set the poles and gear ratio.
@bobadingo
Жыл бұрын
@@pilot482 so I'm running a large OutRunner motor which is a 28 Pole on 14 cells in a 35% extra 300, and the tachometer on the radio only shows 642 which I assume is 6,420 rpm ,I talked with Futaba technicians Ian and Tony & said to update radio but my radio is brand new just bought it 2 months ago and I have a 14 SG that does not have this problem but yes you do have to set the radioTelemetry RPM to the correct number of poles of the motor to get the correct RPM reading that I did , but it's not showing the correct amount of numbers on the display.. .
@franforriol1564
11 ай бұрын
Hello mate, I was looking for information about this fan and I just came across this video. Do you have more information about the fan's thrust at different velocities? Actually, any data regarding thrust/pressure jump would be highly useful to see if it would fit in my case. I would be highly interested, as the manufacturer does not provide any information. Thanks!
@pilot482
11 ай бұрын
Sorry. I didn't think about testing for that. I did move the throttle to about half and go around 8 pounds with a much lower amp draw on the ESC. But I don't have any more than that.
@BertholdStadler
Жыл бұрын
Hello, thx for the test but the rpm from the motor cannot be right? You have a motor with 685 kv with 12S. On the Telemetrie i saw 15.700 rpm 🤔 Motorpole wrong in the setup from Telemetrie ? By
@pilot482
Жыл бұрын
I may not have the number of poles set in the TX. I can't remember. I was more interested in the amps, thrust and ESC temp.
@prasannasathi3269
Жыл бұрын
Hi saw ur edf thrust testing video Can u tell me which campeny edf U used for that
@pilot482
Жыл бұрын
All the equipment is listed in the description. I bought the fan/motor through TurbinesRC.
@user-fs5ir5eh7q
5 ай бұрын
모터 제품명 ? 판매처 링크
@dewagedeprayoga9051
8 ай бұрын
How much rpm?
@pilot482
8 ай бұрын
I can't quite remember but the math on the 685kv motor and a full set of 12S batteries would be a max around 34,000 rpm.
Пікірлер: 29