Hello folks, and welcome back to the e-bike build series! In this video I'm going to show you how I repurposed M50lt cells that I salvaged from warehouse robot batteries to build a 5.6kWh li-ion battery for my custom electric motorcycle, and used my 3D printer and laser engraver/cutter to make an enclosure for them.
E-moto Gen II project playlist:
• E-Moto Gen II Build
M50LT modules that I repurposed:
batteryhookup....
Nickel strips:
gridrewired.co...
High speed PETG filament:
3dprintingcana...
3mm acrylic sheet:
plasticworld.c...
kWeld spot welder:
gridrewired.co...
Qidi XMAX 3 CoreXY 3D Printer:
US - s.zbanx.com/r/...
EU - s.zbanx.com/r/...
Battery strip ampacity chart:
evolveforums.c...
Copper bus bar ampacity chart:
www.copper.org...
Wire size calculator:
www.omnicalcul...
#electricmotorcycle #ebike #emoto #diybattery
My website: www.resystech.com
Support me on Patreon or KZitem and earn membership perks:
/ resystech
/ @jamesbiggar
Follow RST on Facebook:
/ renewablesystemstechno...
Негізгі бет Тәжірибелік нұсқаулар және стиль Electric Motorcycle E-Bike Build - Ep 4: Complete 5.6kWh Battery Build - 3D Printing - Laser Cutting
Пікірлер: 54