Very impressive. Great work, great vid. Would have liked to have seen the process of putting it all together though. Including the sheetwork for the hood. 👍🏽👍🏽
@javierandrade7756
4 жыл бұрын
Buen trabajo!! Gracias por compartir su trabajo e ideas!
@Tiersmoke92555
4 жыл бұрын
Waiting on you next video
@theodricaethelfrith
Жыл бұрын
What motor did you use for this? Is it a forklift motor, or something more exotic?
@WillieStubbs
6 жыл бұрын
very nice
@bobhotchkiss2438
4 жыл бұрын
I am looking to make a very similar conversion to an 8n. Well, really the exact same conversion, except for voltage and the fabricated frame and sheet metal parts. There really are not a lot of these conversions out there to find on the net as far as I can tell. Yours is only the fourth I've seen so far. One didn't mention what they did concerning the clutch, another retained it, you deleted it, and I forgot what the other did. But I'm not sure what function the clutch would really serve. Maybe I'm just not "getting it". But I'd like to understand why you wish you had retained it, because if I'm not "getting it", I want to figure that out before I go down the wrong road. Even with the clutch, you can't bring the PTO up to rpm or lift the 3 point, and then start the tractor forward by feathering the clutch. Because the moment you push the clutch in to put the tractor in gear, the PTO and internal hydraulic pump stop. It's just how the early N series are built, they don't have nested input shafts that power the PTO shaft even while the clutch is pushed in.
@CarlosLopez-ov4bp
3 жыл бұрын
Are you planning on making some videos on your conversation? I want to get there eventually on an 8n also.
@bobhotchkiss2438
3 жыл бұрын
@@CarlosLopez-ov4bp I wasn't, but since you're asking - I'll be sure to make some video.
@electricvahicals88
4 жыл бұрын
Sir pls make tractor convert in electric details video
@antoniof.zamora2330
4 жыл бұрын
Great!...
@timbylander7015
Жыл бұрын
Why would you want to keep the clutch? Just interested.
@benbament7424
6 жыл бұрын
Just out of interest why would you keep the clutch if you did this again? I am looking at a similar conversion and was planning on bypassing the clutch like you did.
@DuncanAitken
5 жыл бұрын
Ease of operation, I suspect. I'm doing a Nuffield 4/60 conversion (2 Leaf motors, 96 LiFePo4 cells) and won't be keeping the clutch.
@djjudd566
4 жыл бұрын
I'm just guessing here, but maybe with a clutch you could run the motor continuously to power hydraulics?
@Gskill2011
5 жыл бұрын
Very nicely done. Did you choose lead acid for easy replacement? I am curious why not lithium which comes in many varieties. You are skillful and resourceful.
@DuncanAitken
5 жыл бұрын
Cost, I suspect?
@SABARMOWER
5 жыл бұрын
Very good idea Mr, good tractor 😀 I need to subscribe you OKE ?
Пікірлер: 18