Contactor is an electromagnetic switch which makes or breaks electrical contacts when electrical signal is provided, it is necessary to use contactors for protection purpose because it's not possible to use manual switches for higher voltage loads. . Whereas Relay can be said as an electromechanical switch which trips and provide protection from overload and other fault conditions depending on type of relay and in some cases when relay trips we have to reset that particular relay after tracing and successfully correcting the fault.
@electrocussolution6857
4 ай бұрын
thanks for you attention
@pradeeprk983
3 ай бұрын
Pls keep continue this types of video
@electrocussolution6857
3 ай бұрын
we will start the series of interview thanks for you appreciation
@NewVecancy1
5 ай бұрын
It's good for everyone who tries to industrial automation.
@electrocussolution6857
5 ай бұрын
thanks for appreciation
@AbelKomora
10 күн бұрын
Very good videos bt try using English only for the sake of those who doesn't understand Indian language ❤
@_vishu7355
8 ай бұрын
Tagda interview 👏
@jayprakashmodi9992
3 ай бұрын
Very best interview
@electrocussolution6857
3 ай бұрын
thanks for your appreciation
@positivethinking3434
10 ай бұрын
Good
@ebmvideo9636
28 күн бұрын
Sir location kya institute ka
@electrocussolution6857
27 күн бұрын
Address: Near Bank Of Baroda, Tedhi Pulia Cahuraha, Kursi Rd, Lucknow, Uttar Pradesh 226021
Пікірлер: 13