This video explains the modeling of ellipsoid head and elliptical head. It also explains the modeling of reinforcing pad modeling around elliptical nozzle using ANSYS Workbench.
Note: The Ellipsoid ID should be 100" instead of 50" in the dimension sketch.
*************************************************
Morning Sun by Nicolai Heidlas Music @nicolai-heidlas
Creative Commons - Attribution 3.0 Unported- CC BY 3.0
creativecommons.org/licenses/b...
a href="www.hooksounds...", Music by HookSounds
*********************************************
Channel Name: #GraspEngineering
Similar Videos:
1. Introduction to practical Finite element analysis
• Practical Introduction...
2. Midsurface, Surface and weld creation using ANSYS Design Modular for Base Frame
• Midsurface, Surface an...
3. Vertical Pressure Vessel Modeling Using ANSYS Design Modular
• Vertical Pressure Vess...
4. 1D beam topside module Structure Modeling using ANSYS workbench Design Modular
• 1D beam topside module...
5. FEA Static Analysis of Pressurized Stop valve using ANSYS Workbench
• ANSYS Tutorials. FEA S...
6. Nozzle Shell Junction FEA Analysis USING ANSYS
• Nozzle Shell Junction ...
7. Bolted Flange Gasket FEA Analysis Usign ANSYS Workbench
• Bolted Flange Gasket F...
8. Hydrostatic Pressure application in ANSYS
• Hydrostatic Pressure A...
9. Vertical Pressure Vessel Hydrostatic test analysis as per ASME Guidelines using ANSYS Workbench
• Pressure Vessel Hydros...
10. Lifting Analysis of Horizontal pressure vessel using two lifting lugs in ANSYS, Part-1
• Lifting Analysis of Ho...
11. Lifting Analysis of Horizontal pressure vessel using four lifting lugs in ANSYS, Part-2
• Lifting Analysis of Ho...
12. Introduction to Rotordynamic Analysis Using ANSYS, PART-1
• Introduction to Rotord...
13. Rotordynamic Modal Analysis of Impeller in ANSYS PART- • Rotordynamic Modal Ana...
Негізгі бет Ellipsoid Head with Eccentric Nozzle & Reinforcing Pad Modelling Using Ansys Design Modeler
Пікірлер: 45