kWh reading of a meter is too much faster, what is the reason??
@savarnchanchal9538
6 жыл бұрын
please suggest to correct the displayed negative power factor value.
@EasyPLC21
3 жыл бұрын
Check the all CT direction
@savarnchanchal9538
3 жыл бұрын
@@EasyPLC21 i did, but still it is showing negative value for all 3 phase. could you please suggest the remedy
@EasyPLC21
3 жыл бұрын
CT have 2 side P1 & P2. Current flow direction P1 to P2. P1 side is connected to Incoming side & P2 is load side. Every CT have 2 terminal aslo s1 & s2. Ct1,ct2 & ct3 all cts s1 is connected to i1+, i2+ & i3+. All cts s2 terminal connect to i- terminal and ground also.
@savarnchanchal9538
3 жыл бұрын
@@EasyPLC21 yes its the same, even then all the power factor readings are negative 😒, could you suggest some change in programming
@rajneeshprasad5886
6 жыл бұрын
Does it have a usb support
@SumanDas-hi4kz
6 жыл бұрын
After edit mode it's showing us LOC R
@kdkgame334
6 жыл бұрын
Bhai metar Mai MWH increase nahi ho rahe kya karu waki shabi reading thik Bata Raha hai bas MWH seme hi shika Raha hai please suggestions me Regards Kuldeep kr. 7055351110
Пікірлер: 14