Holmz Law's
4 Point Saddle - Edge of Obstruction Method
In this video I'll teach you step by step how to accurately bend a 4 point saddle. The method used is called in the trade the edge of obstruction method. Reason being is because you measure from the end of the conduit to the edge of the obstruction you are trying to bend over. I must say that before you watch this video you should at least know how to bend an offset and know the multipliers of offsets and also know how to calculate shrink. If you don't already know how to then I advise you to watch my video on how to bend an offset or any video for that matter on the subject. I will put the multipliers in this description and shrink as well in case you need a reminder. Please like, share and subscribe. Thank you.
Offset Multipliers & Shrink
10 Degree= 5.67 Shrink= 1/16
22.5 Degree= 2.6 Shrink= 3/16 Inch
30 Degree= 2 Shrink= 1/4 Inch
45 Degree=1.414 Shrink= 3/8 inch
60 Degree= 1.15 Shrink= 1/2 inch
Please follow me on these social medias and communities:
Facebook/holmzlaw
Facebook/The Art of Conduit bending
Snapchat/holmzlaw
Instagram/holmzlaw
www.Linkedin.com/in/Melvin-Rubio
Twitter/holmzlaw
Tradehounds/holmzlaw
Reddit/holmzlaw
Reddit/r/conduitology
#4pointsaddle#emt#holmzlaw
Негізгі бет EMT Conduit Bending: 4 Point Saddle, Edge of Obstruction Method
Пікірлер: 65