Drift Test video: kzitem.info/news/bejne/smiYnqdvoH5me6w Video versi Bahasa Indonesia: kzitem.info/news/bejne/xIWg1KJ5pqppgI4
@rileybirkett6106
Жыл бұрын
any chance you could comment a list of all the screws, nuts, bolts and any other hardware bits you used? just to make it easier to get everything at once. also great job, very nice rwd conversion.
@Tinvan_real
Ай бұрын
does that gyro run on a 3s lipo?
@gogreen2189
Жыл бұрын
👍❤️
@шатазн
Жыл бұрын
yo bro, u should really use cvd shafts/axle, it really helps remove any vibration at the rear wheels
@gadogamix
Жыл бұрын
That's right bro. maybe some other times :)
@khairulatta2778
Жыл бұрын
Need a new screw to assemble?
@elmyka4885
Жыл бұрын
Yup
@VT2GUP
Жыл бұрын
I have just printed the parts and they all seem weak and aren’t joined properly o think they have faulty files? Can you please fix this
@gadogamix
Жыл бұрын
If you use it for drift only, it should be fine. But never use it for rally or even on road with rubber tire, it won't be strong enough or at least it wont last long. Actually several days ago I use it for speeding on road and all is works fine until I hit solid objects (and it breaks). Then I reprint with same files, still working fine until today.
@VT2GUP
Жыл бұрын
@@gadogamix I am only using for drift and I made it work but the upper base and the servo horn both snapped and had to be screwed back together just when removing from the printer your files need to be updated and make sure all the parts are recognised as one piece some of them weren’t merged together properly and printed recognises it as 2 seperate parts. Other than that works great
@gadogamix
Жыл бұрын
I'm sorry, but I've tried with same files and it works fine. Other people try it too without problem. I'm using Cura slicer version 4.13.1 with 20% infill.
@VT2GUP
Жыл бұрын
@@gadogamix I ran 100% infill not sure what program but the lower arms had a weak spot and so did upper base im going to try and edit the files a little to suit the printer I’m using, other than that the kit works great
@daniallim9988
3 ай бұрын
WHAT SAIZ IS THE M2 BOLT😭
@gw-1kenji186
Жыл бұрын
Oh hey, that's a nice direct drive system 👀🤔 actually mind if I ask if it's possible for me to sell pre-printed sets of your kit on my shopee?😅 It makes it easier for some people if they wanted to get your parts over here if they dont have a 3d printer 🤔
@gadogamix
Жыл бұрын
Of course, you can sell the end (printed) product. I won't ask for commission 👌
@igori7877
Жыл бұрын
Get to the track and compare you Fish with real drift car - ask someone's car to drive
@gadogamix
Жыл бұрын
It still can't compete with real drift car like Sakura D5, YD2, Or MST RMX. Many factors involved like chassis flexibility, motor direction, weight distribution and so on. HSP FF can drift, but it will be harder to maintain big drift angle, especially on long track. However, HSP FF will be more suitable for gymkhana type race.
Пікірлер: 18