How do I simply eliminate the vertical axis? I’ve seen it on another video. The guy showed that it’s possible possible but of course did not explain anything and it literally took him five seconds. he had the laser going through all of its auto programs and at first the laser is going up and down and left and right and he pressed one button and had the laser going completely horizontal and it looked amazing. I’ve been asking this question on so many videos. Still haven’t gotten an answer. Six months later for some reason. I appreciate your help.
@jhrlasers
4 жыл бұрын
Ah, Now I understand, Better :)
@ander5332
3 жыл бұрын
Hi, nice video, can I use that program for another tipe of laser?
@jaggofficial7954
3 жыл бұрын
Any analog ilda laser!
@duckfactory
3 жыл бұрын
Hi Can Optlaser fb4 support qs5 or beyond5?
@ryanjoubert3420
11 ай бұрын
Hi there, I am connecting a Lasercube to my FB4 via ILDA. Ethernet is connected to my PC. For some reason QS can see my FB4 and I get the red blinking light on my FB4 when enabling laser projection, but the laser is not projecting anything. Do you have any ideas?
@ahmad_km2110
5 ай бұрын
What is the cheapest laser that i can program via pc to start with ?
@markjones2550
3 жыл бұрын
good job
@joeliang9781
4 жыл бұрын
Hi, Is the projector in the video are OPT laser?
@EmileChauvinLaser
4 жыл бұрын
No it's not ! :) ECS BeamBox 3w here, with FB4 build in !
@nsrlightslaser1515
Жыл бұрын
Can I do this multiple laser animation and 1. fb3
@djomkar989
2 жыл бұрын
When I click on enable laser there show connect with hardware
Пікірлер: 13