⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: kzitem.info/rock/k_lcDzEWLs5fVRYceK3-9Q ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
@parkerdarian3853
3 жыл бұрын
a trick: watch movies on Flixzone. Me and my gf have been using them for watching all kinds of movies during the lockdown.
@braylenalberto6461
3 жыл бұрын
@Parker Darian yea, I've been watching on Flixzone} for since november myself :D
@--Skip--
2 жыл бұрын
I know he has the motor out of the chassis to show the parts, however it would be far better if they filmed with the motor in the vehicle. The installed motor is what the average person has to contend with with all the tight, lack or space, removing and installing the starter.
@datguystew1625
4 жыл бұрын
10:30 when they get to the starter
@aundrathomas4909
4 жыл бұрын
Thanks!
@xavierhuertas4946
4 жыл бұрын
This is the worst video I've ever seen smh
@rondellschuyler7074
3 жыл бұрын
American cars are becoming difficult even for dealership mechanics to service. Engineers obviously do not care.
@SuperLibertarianMan
Жыл бұрын
There should be a national "Kick An Engineer In The Nuts Day!"
@brianwynn3681
2 жыл бұрын
Takes about 3.6 hours. Top bolt is 16mm. Super tight. Very difficult to get to. Pain
@Fortworthman999
Жыл бұрын
At 5:44 you can see the upper starter bolt right below his index finger. I'm thinking a u-joint and extension will get it out without taking intake off.
@nabeeliq4666
2 жыл бұрын
Uper bolt is 16mm **
@user-qq8vs9cc2f
Жыл бұрын
hello, i have no experience and had to do this job myself. Following along with the video I was taking off the manifold and dropped an extension and a socket down into it. I have since bypassed the manifold altogether and completed the starter. However I still have the problem of the tools being inside my manifold now. I have made a magnet on a bendable hose and couple a of other things and no luck.. Can someone please tell me of a tool that actually works to remove the bolts in the manifold while its still in the car. I cannot find anything to fit that will work because of the firewall. HELP
@RelaxFurls
4 жыл бұрын
After doing all this I realized the starter can be removed by only Removing the bottom intake bracket. Then I watched this again and realized you typed in in Tiny letters in the beginning. STUPID!!!
Пікірлер: 17