You should add a bilge pump, and maybe a trolling motor for taxying
@cirovirha768
Ай бұрын
You can integrade the rail in the door and the sloders head gets attatched to the planes hull, so the rail is just on the inside of the door moving on the plane.
@s.j7880
Ай бұрын
I think in the tail it would be cool to have a smaller boat or a mini sub!
@park0urpulse
Ай бұрын
You could add a sleeping quarters/living quarters in the back section behind the rescue doors
@davidlawand2805
Ай бұрын
now you can check the COG of the plane by extending the wings in the dock
@thadaagaard6648
Ай бұрын
Wedge blocks are half weight.
@qazxsw21000
Ай бұрын
The buttons to open/close the doors become inaccessible from the inside when opened lol
@ProfNCognito
Ай бұрын
@qazxsw21000 lol I noticed this during editing. Great catch!
@0Bunker-buster0
Ай бұрын
Can make a triple propeller plane 2 on the wings and one on top so u can use the top one for taxing and turn on the 2 others for takeoffs
@WessexBambi
Ай бұрын
I think as well as using the under area as a med bay you should have a hatch on the roof for pilot entry from the dock
@AverageCanadianHunter
Ай бұрын
I said that too it would be useful for maintenance on engines
@WessexBambi
Ай бұрын
@@AverageCanadianHunter he just mentioned both our comments in the new video
@AverageCanadianHunter
Ай бұрын
@@WessexBambi I’ll have to check it out!
@HanMandle
Ай бұрын
I'm included.
@moni9710
Ай бұрын
This looks amazing!
@opeix
Ай бұрын
Can you build a space ship?
@samuelgutierrez1043
Ай бұрын
I think i discovered a buoyancy glitch in Trailmakers, so please make a video about it. Step 1: place rotating servo to right of gocart seat (connect them with a shield 2x4) Step 2: in the top right of the servo place a steering hinge with the green arrow facing the side of the seat. Step 3: on top of hinge place a wedge 1x2 with the slope facing the seat. Step 4: On the wedge place a tailfin, make sure it's on its side with the front slope facing the center of the wedge then do this step 1 more time on that same side. Step 5: on the rotating servo set the duration and pause to 0.05 Step 6: Do Steps 2-5 on the opposite side Step 7: place a stabilizer on the back of the gocart seat and a sensor thats always on in the front. Step 8: connect the sensor to the hinges and make sure that both servos are turning to the front of the seat Then you are done! For some reason, when the servos are turning in the water, the whole vehicle will float up, otherwise it will sink.
Пікірлер: 21