This is an episode made in collaboration with my own DIY PCB series. In this episode I will walk you through how to make the code I made for a ATtiny1616 which controls various aspects of that UV Exposer Box. Actually, there is allot of good stuff in this episode, so I highly recommend you check it out!
This is the sixth episode in a series where I will be providing some practical lessons on how to write programs using Arduino. These lessons are intended to be useful information that you can use in your own code immediately, but I also hope it serves as a general lesson to get you thinking about how to write code better.
Негізгі бет Ғылым және технология EP6 - How to Program Arduino - Full Listing for UV Box Timer
Пікірлер: 13