Thank you very much for your video helped a lot I just ordered the set thank you again by the way I’m from San Francisco California thanks
@mikepocock575
2 жыл бұрын
Another cracking vid Spen,and yes we had a great thunderstorm too mate.Take care.
@mikenelson8786
2 жыл бұрын
Please add that to ensure long life of collet the metal being held needs to be of good surface finish. Metal with rough surface or black scale is not really appropriate! Keep them coming!
@nicholaspratt7934
2 жыл бұрын
Smart shirt 👍
@ktm.al477
Жыл бұрын
Hello Spen A while ago I think you mentioned that you replaced the dog clutch in your lathe. I have just stripped the clutch mechanism and the pin on the end of the engage handle is warn. Was this your problem or was it the actual clutch? I will try and contact Clarke spares dept tomorrow, but I don't hold out much hope. I might have to try and make one out of tool steel perhaps.
@SpenCrowson
Жыл бұрын
That is one of the weak points. When I stripped mine to replace the bearing I also fount the pin mechanism worn, parts 18 & 29 on page 18 of the parts list. It had been loose for ages. Luckily I'd been given some spares a while back.
@ktm.al477
Жыл бұрын
@@SpenCrowson Thank you for your reply. The part 29 with the worm pin, now looking at it. I might just rotate it 180Deg and insert a 4mm pin in it, re drilling the dimple for the handle locating screw. Or make another without the O ring grove to give the pin a bit more meat to drill in and fix pin to. I may even have a go using my rotary table on the new to me mill to make the pin and barrel in one piece Cheers Alec
Пікірлер: 7