Learn how to set up your first ESP IDF project using Visual Studio Code, from scratch. We will build a simple example using GPIOs to learn the basics of IDF and how to navigate through the code and documentation.
We will also learn how to use the menuconfig, a very helpful tool to configure the main settings for our project.
If you like this video, please give it a thumbs up and don't forget to subscribe :)
❗❗❗ IMPORTANT ❗❗❗
⚠️How to configure your IDF terminal inside Visual Studio code: • ESP32 - Getting Starte...
You will need this for this video.
** Regarding CMAKE **
For a list of reserved words to avoid in your project name, type the following in the IDF terminal:
cmake --help-command-list
cmake --help-variable-list
cmake --help-property-list
▶️ How to Debug your ESP32:
• ESP32 - DEBUGGING your...
✅ ESP32 Board Links (Affiliate)
✔ Amazon (Faster shipping)
ESP32 Board - amzn.to/3weY6SA
Debugger ESP-PROG (Recommended): amzn.to/3ENsSDy
Debugger FT2232H Generic : amzn.to/3B1Bxjp
Debugger FT2232H Generic Dual Channel: amzn.to/3C0NG9G
✔ AliExpress (From China - Cheaper but slower shipping)
ESP32 Board - s.click.aliexpress.com/e/_AXDp1R
Debugger ESP-PROG (Recommended): s.click.aliexpress.com/e/_A9n4lJ
Debugger FT2232H Generic: s.click.aliexpress.com/e/_Ap4yQt
Debugger FT2232H Generic Dual Channel: s.click.aliexpress.com/e/_9ycDvF
** Timestamps **
00:00 Introduction
00:40 Why use IDF?
01:17 Setting up the project
02:46 How to use Menuconfig
04:17 Configuring the main settings
06:12 Setting the Firmware version
06:42 Build folder run through
07:25 Coding Example
08:10 GPIO Driver
09:08 GPIO Input Config
10:19 GPIO Pull-up Config
11:06 GPIO Output Config
11:19 GPIO Reading the Input and Activating the Output
12:11 About the vTaskDelay()
12:49 Final Test
12:57 Outro
Негізгі бет Ғылым және технология ESP32 - How to create your First ESP IDF project (From Scratch)
Пікірлер: 232