That's my ZLX. We've used it for about a dozen rehearsals since then, and it's still working. Thanks again!
@joeride5672
25 күн бұрын
I have the same problem with my LD ICOA 12A-BT. From the power supply output has +15 and -15 volt and 3.3 volt, but the LCD Screen on the input board doesn't turn on. Any suggestions?
@djdoesha
Жыл бұрын
What state you in ?? I need help ‘ My speaker doesn’t work turns on, but has a popping signal when you turn it up
@TheDeedeeFiles
4 жыл бұрын
Cool video my friend
@clintronicsrva
4 жыл бұрын
I am working on another ZLX12P and IT uses 100K resistors and the R numbers dont match. So obviously there are two versions of this PCB
@Bilawalrz
Жыл бұрын
Whats the output voltage of transformer in power supply circuit??
@djbreidytbm8405
3 жыл бұрын
Hello, would you help me with this failure when raising ZLX12p it throws me a message between the two signal inputs that says "HOT" and after a few seconds the word HOT is shown on the much larger screen, no audio signal reaches all the speaker I would appreciate your help, thank you
@clintronicsrva
3 жыл бұрын
Is anything actually getting hot? I didnt know it had this feature. Ive never seen it. there must be a thermal sensor on the heatsink getting triggered. Figure out which part is getting hot.
@MrAletube
4 жыл бұрын
Which microscope are you using?
@clintronicsrva
4 жыл бұрын
AmScope SE402X 5X-10X-20X Binocular Boom Arm Stereo Microscope + Light
Пікірлер: 10