The highest levels of skill, quality-commitment, and knowledge
@dennisedwards8954
4 ай бұрын
I have absolutely no reason to be watching this particular video. So, here I am. I have the cat on my lap and am two coffees into the morning, engrossed by the video presentation and author's delivery and enjoying every second of the video and even rewinding at times to review. I wonder whether somewhere deep inside me there's a mechanic striving to get out.
@wish2fish37
Жыл бұрын
Thanks for starting this series.Very educational.
@peterjensen6844
Жыл бұрын
Honestly the engine being full of oil probably saved a ton of corrosion.
@iride365
8 ай бұрын
I have the same motor. Fuel pump always seems to be an issue. They are very hard to find these days
@squiddly-diddly
Жыл бұрын
100 + lbs .. ! That's why I love my Suzi 15 2stroke... 68 lb. 👍👍
@AbbyNormalGarage
Жыл бұрын
Facts!
@jacobthompson3180
20 күн бұрын
Thank you for this, I just bought one from a guy close to cedar city
@robertkeaney7047
Жыл бұрын
Short or long videos doesn't matter. I watch them all. Good work B.
@peterjensen6844
Жыл бұрын
It sounds real nice fuel pump issues aside. Nice find for sure. Someone will pay good money for that as a kicker or trolling motor.
@rdgurule
Жыл бұрын
I love my 4 stroke Yamaha kicker. Upper in the PNW four stroke Yamaha kickers are on nearly every fishing boat. With four stroke Mercs a close 2nd.
@darellsunderlin4670
8 ай бұрын
Ive workef on 2 and 4 cycle engines for close to 40 years and have seen many 4 strokes with fuel or oil hydo locked cylinders. If its oil, they have tipped it over to the carb side, and depending on how the valves stopped, it will determine where the oil will go . If it stops with the intake valve open, it can go into the carb , if it's the exhaust, it will go into the muffller .gas can do the same . This is on something like a lawnmower etc .
@jeffbrummette1622
Жыл бұрын
As usual you are the boss of them engines! You amaze me with your knowledge of these motors! But I would appreciate more videos of these fixes! Way to go Brandon!👏👏👏👏
@darreldirstine304
Жыл бұрын
Pop pop⁰⁷9mm
@alg335
Жыл бұрын
Great vid!
@MexicoPescadoro
Жыл бұрын
Bro, you have to check out the solder seal connectors. I'll never crimp again for the rest of my life. These are so easy to use and they seal well.
@peterjensen6844
Жыл бұрын
This is the way.
@lucaslounsbury8515
6 ай бұрын
you can lay them in a truck theres a certain side to lay it on to avoid oil in the cylinders
@bigjay6743
2 ай бұрын
I have one of these engines and there's nothing you can do they are very cold-blooded.
@dwayneivie3350
Жыл бұрын
sure like this video and looking for the followup that to come., in am from good old Cedar City mysellf.. i had a new 15hp elec start model omc when i worked for Brinkmans in vallejo,cal. to me the best small out in this class was the last gen Merc two stroke, i have a merc 15 hp 4 stroke now.and a 2..5 hp 4stroke. also.
@clintdunning6841
Жыл бұрын
Really enjoy your videos sir!! What’s the best way for a fellow Arizonan to get ahold of you for some future boat repairs. Thanks!!
@rossfenneken
Жыл бұрын
Same spark plug as every Harley Davidson I've had. Recognized that part number.
@goldtonestudio4471
5 ай бұрын
The fuel pump on these fall apart inside and cause the dying problem, I have a LOT of hours into mine after almost 20 years and still have problems, the next thing I’m gonna do is try to fix the weak peeing, it’s overheating after 10min under load, probably mud dauber in the water pump hose.
@stewart-fj5jj
11 ай бұрын
Hi again Brandon thanks for your reply.can you now tell me where you are and where your workshop is located please ,I intend to visit you when I am out that way .many thanks stewart
@dfabeagle718
Жыл бұрын
The Chinesium push lawn mower engines / power washers are the same way. Always 2 pulls... or 1 if you're fast enough to push the choke in. They always seem to want one pull with choke, smoking hot or ice cold. (edit) I wonder if it has to do with the compression release.
@leonardhirtle3645
Жыл бұрын
Bring back the 2 strokes.
@allynwadleigh2210
Жыл бұрын
They should have switched to the four stroke and maybe they would still be in business!
@michaelnelson912
Жыл бұрын
I’ve worked on a brand new Yamaha 9.8 hp 4-stroke that wouldn’t start because of oil in the carburettor. It was from being transported lying the wrong way up! Easy fix, but on a new motor that’s never been run?
@davekimbler2308
Жыл бұрын
4strokes now ?? Well I guess it’s going to happen sooner or later ! Quiet YES Heavy YES Speedy NO Basically it’s a Briggs motor ! Was it your camera or did it have a bad vibration? If it’s not right for that boat then what boat is it good on ? A bigger and heavier boat = less speed I don’t know .
@danstoops8501
24 күн бұрын
Do you work on customers outboards? I have a 30hp Etec that would really appreciate your touch
@bennyblanko3
Жыл бұрын
Thanks!
@justtoysociety8990
4 ай бұрын
Too bad this was years ago lol. I just bought a semi nice one and got stranded on the lake. Definitely had the motor on its side. Definitely got oil in the carb. But it ran perfectly then would start run and die every time after lol. I completely replaced the carb only to find out my damn primer bulb was bad an the gas tank. Haven’t take. Her back out on the lake simply cuz I don’t wanna drain and fill the oil every trip. If you were to suggest a side to lay it on would it be carb and oil filter facing up??
@justtoysociety8990
4 ай бұрын
Carb or oil filter***
@Brewmaster721
2 ай бұрын
I have a 98 evinrude 9.9 4 stroke. It runs fine until well up to temperature. It is putting out water cooling tube when running. At wide open throttle, the engine is only at idle Any thoughts?
@waynewolfe8817
3 ай бұрын
I have a 96 9.9 hp marc the plug gap is .060"
@randy1ization
6 ай бұрын
when you start it sometimes I see it cough out the carburetor ,, wondering if it needs a small valve adjustment..
@BrandonsGarage
6 ай бұрын
Probably. But it's the idle circle, so it fine if I don't idle. ;)
@stewart-fj5jj
11 ай бұрын
Hey Brandon please tell me where the river is located where you try out your outboards. Thank you Stewart.
@BrandonsGarage
11 ай бұрын
That's the Colorado River, launching from Needles, CA
@coastalcleaningandmaintena2884
Жыл бұрын
You can transport on the aide no problem. For honda i know u lay it tiller up. Merc is opposie i beleive.
@wesb6327
6 ай бұрын
Got any extra good cdi boxes for these you want to sell?
@champlllloyd7461
6 ай бұрын
How can I get a gas pump for one
@PunkR0ckz09
Жыл бұрын
Hi BRandon, I was wondering, is there a way to add a "Touch Troll" kit to an Evinrude Etec, remote controled, that isn't an "AFA, "AB" or "AGA" model? For example, the one I'm looking to buy is a E15HPSLAA, so I assume that's an "AA" model, and I wonder why it can't be controled with a "touch troll" kit, just like a tiller version can, it seems pretty weird to me.
@nvmike24
Жыл бұрын
Have you heard of the campvention?
@BrandonsGarage
Жыл бұрын
No?
@ralphjohnson4041
Жыл бұрын
Don’t you need to change the oil and filter?
@AB-bg1or
7 ай бұрын
Brandon, I have the 15hp version of this abomination. There is an accelerator pump under the carb that leads to the tell tale. This doesn't look right to me and I can't find anything in the service manual. Any help?
@wesb6327
6 ай бұрын
I have a 15hp as well. Yhats the difference between 9.9 and 15 is that accel pump.
@AB-bg1or
6 ай бұрын
@@wesb6327 I finally figured it out. The line under that pump was plugged. I ran a small drill bit through it and it's now pumping water. This thing has been the biggest POS outboard I've ever owned.
@jeremyaustin9103
Жыл бұрын
Is this related to Suzuki? Looks very very familiar to my 25hp suz.
@coastalcleaningandmaintena2884
Жыл бұрын
BRANDON how big was that aluminum. Im buying a boat and dont want something that wont plane out
@ct1762
Жыл бұрын
anything under 175lbs is what you want. a 14' is ideal, and the 15hp version of this motor is more enjoyable.
@geesss8675
Жыл бұрын
Who made that for OMC? Kazuki
@BrandonsGarage
Жыл бұрын
OMC Manufactured
@waynegalvin4639
Жыл бұрын
@@BrandonsGarageinteresting, I wondered if it was Japanese sourced.
@scottmann1015
Жыл бұрын
Sure looks like a Tahatsu almost every brand under 20hp is
@waynegalvin4639
Жыл бұрын
@@scottmann1015 I had no idea.
@Goomer
Жыл бұрын
Are they more fuel efficient than say a 1970 Johnson 9.5?
@BrandonsGarage
Жыл бұрын
Yeah, about half the fuel consumption.
@dougaranda6187
Жыл бұрын
There’s no way there will ever be a 50 y/o 4-stroke. Just too many moving parts and maintenance.
@leonardhirtle3645
Жыл бұрын
My ‘91 20hp Merc weighs 112 lbs.
@ct1762
Жыл бұрын
25hp is the same as well. legendary little beasts!
@ct1762
Жыл бұрын
these where highly problematic. OMC original design just nudged them closer to bankruptcy. bought them from Suzuki when BRP took over. had many issues with fuel pumps. they appear the same for te 3-15hp motors so easy enough to replace i'd think. i doubt the valves have moved much or atleast are the issue. these things are notorious for bringing you down the wrong rabbit-hole.
@AB-bg1or
7 ай бұрын
I inherited the 15hp version about 5 years ago. About once a year I take it out and try to get it going and have failed. I can get it to run for about 10 minutes then dies. I think it's overheating. Weird thing is the tell tale is hooked up to what I think is an accelerator pump mounted under the carb. I broke down and bought the factory manual and can't find anything about the cooling system or that accelerator pump. This abomination of a motor is kicking my rear, but I refuse to give up on it.
@scottmann1015
Жыл бұрын
All or most 4 strokes lay only on one side the other side fills the cylinders full of crank oil
@dfabeagle718
Жыл бұрын
Yep, same thing for mowers. You lean it over on the wrong side (carb down), the PCV valve lets oil into the carb.
@murraymadness4674
Жыл бұрын
Maybe some dumb tech thought it was a 2 stroke and put motor oil in the gas?? lol It is a resort, they hire 14 year olds.. The taped over oil can was hilarious, welldone.
@leonardhirtle3645
Жыл бұрын
4stroke outboards are crap. I love my 2strokes.
@lustfulvengance
Жыл бұрын
Cant beat the power to weight ratio of a 2 stroke!
@billythekid5196
Жыл бұрын
Its just from being on wrong side im sure fourstroke outboards are lame
Пікірлер: 70