When creating the base flange at 14:20.. why not create a miter flange along the base flange with the extruded cut? You could sketch the whole profile and I think you can offset from an edge in the miter flange tool too. (I haven't taken the CSWP-SM yet)
@shawnz3307
6 жыл бұрын
Yes, miter flange works too. I was new to sheet metal design by then┑( ̄Д  ̄)┍
@rshadix86
3 жыл бұрын
I thought this was by far the hardest of the 5 advanced tests. It didn't help that the official practice test has virtually nothing to do with the actual material being tested on.
@preetinair3447
3 жыл бұрын
Totally agree with you. Plus the sample does not come with all the questions.
@jotaga1390
6 жыл бұрын
Hello Shawn! Did you upload a surface certification video some months ago?? Can you share it again???
@shawnzhang9793
6 жыл бұрын
I did pass the surface certification before but I don't think I make a video about it. I could share some experience about it if you'd like. Just shoot me an email.
@jotaga1390
6 жыл бұрын
Sure, what's your email or webpage?
@shawnzhang9793
6 жыл бұрын
szhangcti@gmail.com
@jotaga1390
6 жыл бұрын
Shawn Zhang I sent you an email, do you received it?
Пікірлер: 10