Nice one guys awesome to see Mario dropping some knowledge!
@patrash
4 жыл бұрын
Thank you for your very informative video, Mario! Excellently explained... ready to sand! ^-^
@willcyr1
4 жыл бұрын
Great video guys!
@markpopich130
Жыл бұрын
Thank you so much! I has horrible whistling and vibrations. I did a bit of sanding and implemented a Donaldson trailing edge and…silence!
@dentonhess5810
Жыл бұрын
Great video. I learned a lot. Thanks so much.
@thibaultgrosse4442
Жыл бұрын
Thank you very much Mario, my foils (Takuma Kujira2) are noisy and vibrating a bit at low speed eg on surfing the swell, both 1250 and 950 sizes, I will gently sand everything (foils, stabs, mast) thanks to your excellent explanations :)
@thibaultgrosse4442
Жыл бұрын
Done :) Time to go testing on the water :)
@interferenz2k3
5 ай бұрын
in this video you sand the pressure side of the stabilizer .. in "How to finish the trailing edge of your Levitaz foil" you explained, that you should sand the low-pressure side .. a bit confusing :D
@LevitazHydrofoils
5 ай бұрын
Yes I understand the confusion. The reason is that acually both works to get the noise to go away and there are different theories around as to what is correct. As Mario said, what is needed is this Donaldson Trailing Edge but the side is not that important.
@dachopper1
4 жыл бұрын
Fantastic video, can you show how to sand the rest of the foils also to keep them at their peak ?
@LevitazHydrofoils
4 жыл бұрын
Hey Nicholas, thank you for your feedback! Would you like a general maintenance video of the foil or something like repairs?
@dachopper1
4 жыл бұрын
@@LevitazHydrofoils it would be absolutely fantastic if you could do both. ( how you recommend to fix scratches near wing tips or on mast ) and also how you recommend to sand the foil after fixing it for max performance/speed) You would be one of the first manufacturer to give this level of support, but it would be greatly appreciated.
@irf888
4 жыл бұрын
@@dachopper1 Agree, ditto. Well said.
@sampep
3 жыл бұрын
@@LevitazHydrofoils repairs of damaged or digned wings would be awesome to see as well!
@LevitazHydrofoils
3 жыл бұрын
@@sampep noted - we have it on our "to film list"
@peterhazelett9797
3 жыл бұрын
Mario, can you help me understand why it is best to create the oblique shape on the pressure side as opposed to the suction side? Looking at the starting profile shape, it would seem more natural to create the Donaldson Cut by altering the suction side of the trailing edge. Thank you.
@dachopper1
4 жыл бұрын
What do you think about using magnetic stainless bolts? and getting a magnetic cap on top of the bolt to reduce turbulence ? ie to plug the bolt while in use
Пікірлер: 17