nice flight!! Question: experienced modeler... just purchased this. I can only find a right -side cutout for one servo. Manual says there are two elevator servos located in rear of fuse. I also see that there is a location cutout inside the fuse under the canopy for a servo... this would be the rudder on a pull-pull system? Where is the left side fuse cutout for the other elevator? Thanks!!
@northsky6544
Жыл бұрын
Hi Noah, the manual applies to many of the PM 3D planes, the 260 can use pull pull but default is one high power servo for Ele and one for the Rud, it saves weight as with mine and it flies great! you can also modify to use two Elev servos by cutting the other side to match and beef up around the section for extra strength
@siscoflyer4338
3 жыл бұрын
Be nice if they tell you what they are using for equipment. Dle 35 or what that’s what it sounds like. How many times do we watch these videos put the recommendations for motor and does not have enough power for model. Just tell us what your using not that hard to do.
@RaviKumar-su1nt
4 жыл бұрын
Hi Ravi
@manuelsuarez8786
3 жыл бұрын
Where can i found the plane??
@northsky6544
Жыл бұрын
I've been hunting for another one, and no one has any in stock😪
Пікірлер: 7