Step 12 is really hard to do and I was trying to pull it through too much of the outer sheave. Also, instead of using whipping twine at the end, it works well to use electrical heat-shrink sheave.
@BottomUPBoats
Ай бұрын
Yep it can be tough depending on the rope you use, with that said the tighter it is the less chance it will come loose with or without the whipping or heat shrink you referenced.
@trondhindenes4412
Ай бұрын
this makes no sense to me. The core is removed early in the tutorial, but later its milked back?
@BottomUPBoats
Ай бұрын
Yes, you need to pull the dyneema out to get enough length to create the eye splice. You then pull the cover over the core to finish the splice off and have dual thickness all the way up to the eye of the splice
@trondhindenes4412
Ай бұрын
@@BottomUPBoats yup - my point was just that the video doesnt actually say anything about pulling the core out first to give room to slide it back.
@BottomUPBoats
Ай бұрын
@@trondhindenes4412 Check out step number 3 at the 1:25 second mark with the link below. kzitem.info/news/bejne/mG6p2Gmij6Z9kn4si=i2VFr1P2uLBupUa2&t=85 This is the 30cm that allows for the inner core to slide back in later in the video and give you the extra length in the outer core used in the final step.
Пікірлер: 6