Thanks, I didn’t know if it had any other nuts that you had to loosen.
@rickroll5150
7 жыл бұрын
just put a wrench on the pulley to walk it on....done
@bolt2510
2 жыл бұрын
I have a question whats the required gear ratio from the starter to the engine to have enough torque to turn over and start ? I plan on implementing one of these starter generators into a go kart build. But I haven’t found any information on what size pully would be required on the engine coming from the starter.
@1beastlydudefixbreakrepeat
2 жыл бұрын
not really sure a pretty good bit I imagine, the starter generators are no joke. from a mechanical point they are more power hungry than a typical starter, they usually run a larger pully and dont have a gear reduction... cant really give you a helpful answer
@bolt2510
2 жыл бұрын
@@1beastlydudefixbreakrepeat ohh if there pretty torquey then they should have much of a problem turning over a small engine like a 16cubic inch motor
@bolt2510
2 жыл бұрын
I have a question I haven’t been ably to find a answer to. What is the required gear ratio from the starter to the engine to have enough torque to turn it over and start it ?
@1beastlydudefixbreakrepeat
2 жыл бұрын
what ever i came with, sorry Im not much help... but what ever ezgo shipped it with is best.. I would go oem if possible.
@bolt2510
2 жыл бұрын
Its a homemade flat bed ag cart i made. I found a 1to4.8 ratio was plenty to start a 250cc engine. I appreciate the help anyway tho!
@nunya8866
7 жыл бұрын
Long story but I took the starter/alt out of my bosses 2002 ez go workhorse golf cart because it wore out. I left one wire attached to it so I'd know my wiring diagram putting it back in. Not realizing they were going to take it and have it rebuilt they took that wire off of it and I don't think it's in the right place when they put the wire back on so now I'm all throwed off as to what wire goes where.. I've googled and googled but no success in finding the actual wiring diagram for the 5 or 6 wires from the cart to the starter. Can anyone help me out and save my butt from wiring it back wrong and burning it up please???
@1beastlydudefixbreakrepeat
7 жыл бұрын
Comfy Tie sorry to hear that man, if I still had this cart I would send you a picture,best I can say is see if any connections line up,they will have a certain bend to em
@nunya8866
7 жыл бұрын
Thanks !
@liveandletlive2894
3 жыл бұрын
@@nunya8866 if you still need I'm working on a campus now with 20 or so of these carts
Пікірлер: 12