Just want to say hands down your videos are the best. I feel like im with my buddies working on stuff. I been having issues with a damn txt series 36 volt and followed your diag videos. Just narrowed it down to this switch(hopefully). Keep posting these videos they really do help. Oh and also we need to do a go fund me for you to get a magnetic volt meter haha. Them things NEVER want to stay where you set them.
@HeyHeyHey97
21 күн бұрын
The magnetic volt meter. Somebody’s needs to patent that. lol. Go fund me sounds good. Lmao. Nah joking. But appreciate the words. What’s your cart doing. Also what voltage did you get on the its. Hit that like and subscribe button for me.
@danielscott8934
28 күн бұрын
It is a 2015 txt 51 volts at battery, switch, solenoid and controller. Replaced ITS, solenoid, micro switch and controller. Controller has 51 volts on B+ 0 volts on B- No voltage drop on M- when pedal is pushed. Solenoid clicks but no movement
@HeyHeyHey97
28 күн бұрын
You have 0 volts on b-? How are you measuring that. Put black lead on b-and red lead on b+ on controller and hit gas and tell me what you get
@HeyHeyHey97
28 күн бұрын
Watch this video. I have part 2 also Ezgo golf cart 48 volt troubleshooting PART 1 kzitem.info/news/bejne/lpeZp3x5hJWjY34
@jakekay5588
21 күн бұрын
Hey hey hey! Great stuff buddy! This is awesome content as always! Sorry I’ve been gone for a minute.
@HeyHeyHey97
21 күн бұрын
Welcome back! I figured you’re tired and were in the Bahamas
@HeyHeyHey97
21 күн бұрын
Welcome back! I’m just tying to make a living.
@jakekay5588
21 күн бұрын
@@HeyHeyHey97 😂🤣
@HeyHeyHey97
20 күн бұрын
Well at least pay the water bill
@danielscott8934
Ай бұрын
Thanks. I’ll try that next.
@HeyHeyHey97
Ай бұрын
k let me know
@KyleWhite-b6l
13 күн бұрын
I am working on a 36 TXT PDS at the moment. I can can make the solenoid hit when you jump it with pack voltage. The reed switch is bypassed for the Summit onboard charger but I have pack votage at the harness. All of the micro switches function but I am only getting 6v when it gets back to the F/R rocker, key switch, and foot switch. The cart has a DCX400 controller on it. Could there be something burnt in the controller after the reed switch?
@HeyHeyHey97
13 күн бұрын
@@KyleWhite-b6l run you a jumper wire from main positive to the small post on sol yellow wire and see if runs
@HeyHeyHey97
13 күн бұрын
@@KyleWhite-b6l also what does voltage show on all 4 post on the tow switch. Black lead on main negative and red lead on tow switch wires one at a time. Leave the black lead on main negative. During the test. And just move the red lead from wire to wire
@HeyHeyHey97
13 күн бұрын
@@KyleWhite-b6l my I just read what you said again and you said you can make the sol click when you give it pack voltage. Does it run when you give it pack bolatge
@HeyHeyHey97
13 күн бұрын
@@KyleWhite-b6l sound like to me either you have low voltage going in. Or the controller is only putting out 6 volt. Which I’ve never seen before but I know how that goes.
@chadsmith1092
14 күн бұрын
Working on a 36v 96 txt. Worked fine till nothing. No clicking at solenoid. Bypassed reed switch, new solenoid, battery bank, and batteries test good. Any suggestions where yo look would be greatly appreciated. Thank you
@HeyHeyHey97
14 күн бұрын
@@chadsmith1092 I am going to share a link with you
@@chadsmith1092 watch these videos both of them are about the same carr
@danielscott8934
Ай бұрын
If the white wire going to the ITS shows 14 volts and the blank side shows the same, is that a problem?
@HeyHeyHey97
Ай бұрын
Replace the its
@danielscott8934
Ай бұрын
I replaced the ITS, controller, solenoid, and batteries. The key switch checks out. Solenoid clicks, but cart won’t run. Any thoughts?
@HeyHeyHey97
Ай бұрын
@@danielscott8934 what does voltage check on everything
@HeyHeyHey97
Ай бұрын
What type of cart is it. Meaning a pds or series
@HeyHeyHey97
Ай бұрын
If it’s a pds Ezgo and the sol clicks and stays engaged till you let go of gas. Check motor. If it’s a series cart and you replaced controller and the f n r looks good check motor.
@bernardjohnson1208
Ай бұрын
Where does the green and the red wire from the micro connect to? An A#$ pulled my wires lose!
@HeyHeyHey97
Ай бұрын
The controller harness
@bernardjohnson1208
Ай бұрын
And what would that look like. It's a Robinson engine. And I can't figure out where this red or green wire connects to!
@HeyHeyHey97
Ай бұрын
@@bernardjohnson1208 oh you have a gas car. Your green connects to the keyswitch and your red comes off the solenoid
@josephsam2776
9 күн бұрын
Where is that switch located??
@HeyHeyHey97
9 күн бұрын
@@josephsam2776 under the floormat
@michaelvogel5300
Ай бұрын
Very helpful, I'll check mine tomorrow. I need your help please. Maybe I could get your number. Thank you for everything you do, Mike
@HeyHeyHey97
Ай бұрын
Thanks for watching and commenting. On my channel I have different levels of member perks. If you want you can take a look at them. And see which one suits you.
@HeyHeyHey97
Ай бұрын
For one on one phone help. You must be a member of my page.
@michaelvogel5300
Ай бұрын
@@HeyHeyHey97 how do I do that I already subscribed
@HeyHeyHey97
Ай бұрын
@michaelvogel5300 wen yo go to my main page it will say member. And just click on it.
Пікірлер: 49