From www.justanswer...
JustAnswer Customer: F6 E1 is the code my whirlpool stove is throwing.
JustAnswer Customer: Even when I set to bake it only uses the broil element.
JustAnswer Customer: I can’t find those codes together in my manual
Pearl Wilson: Assistant: Do you know the model of your Whirlpool stove?
Pearl Wilson: Assistant: How old is it?
JustAnswer Customer: No but between 2-3 years old
Pearl Wilson: Assistant: How long has this been going on with your Whirlpool stove?
Pearl Wilson: Assistant: What have you tried so far?
JustAnswer Customer: did it about 2 months ago, turned it off, used it next day fine.
JustAnswer Customer: Did it just this evening again and I’ve cut circuit breaker off right now tried that earlier but didn’t work
Pearl Wilson: Assistant: Anything else we should know to help you best?
JustAnswer Customer: nothing else I know of
Joel Swenson: : Hello, I'm Joel and will be glad to help you today.
Joel Swenson: : Please provide me with the model number of the unit you are needing help with so that I can give you model specific information.
Joel Swenson: : Please keep in mind once you give me the model number I may have to look up part numbers and reference material for your model so if I don't respond instantly please understand I am working on your answer and it may take a few minutes.
Joel Swenson: : Thank you for your patience.
Joel Swenson: : Also at some point the site is gonna send you a automated phone call request, I am not sending that request so if you don't need me to call just ignore it.
JustAnswer Customer: Don't have model #
JustAnswer Customer: Might be(#) #-#
JustAnswer Customer: Customer attachment 4/26/2020 10:22:03 PM
Joel Swenson: : open the oven door and look for a tag on the oven frame that has the model and serial number on it, if it has a pull out drawer at the bottom pull the drawer out and look on the frame behind the drawer and it should be there.
JustAnswer Customer: WFE525S0HV0
JustAnswer Customer: Do you need serial?
JustAnswer Customer: R80225892
Joel Swenson: : Thanks for that info give me just a minute to write you up some information on this , thanks.
JustAnswer Customer: Thanks!
Joel Swenson: : There are not any F6 codes on that model, could it have been F5 E1?
JustAnswer Customer: It definitely was F6
JustAnswer Customer: Which I don't see in my manual either
JustAnswer Customer: All I know is when I press bake, broiler element comes on, stays on and burns my food and the err starts flashing and codes
JustAnswer Customer: It says ERR
JustAnswer Customer: The F6 then off then E1 then Err again
JustAnswer Customer: I have circuit cut off now
JustAnswer Customer: It did this about 2 months ago and the next day it worked fine.
JustAnswer Customer: Hadn't done it since until today
Joel Swenson: : ok power back on and Press CANCEL CANCEL START to enter the Diagnostics Mode, see what code it is showing in diagnostics.
JustAnswer Customer: Ok
JustAnswer Customer: T at
JustAnswer Customer: T st is showing
JustAnswer Customer: Customer attachment 4/26/2020 10:46:19 PM
JustAnswer Customer: What now?
Joel Swenson: : press the up arrow or + key about five times or until you see an F code.
JustAnswer Customer: F6
JustAnswer Customer: Then err
JustAnswer Customer: Flashing and then E1
JustAnswer Customer: Customer attachment 4/26/2020 10:49:18 PM
JustAnswer Customer: Customer attachment 4/26/2020 10:49:59 PM
JustAnswer Customer: Customer attachment 4/26/2020 10:50:14 PM
JustAnswer Customer: Do I let it keep blinking or hit end
Joel Swenson: : Ok that is strange because the model does not show usage of the code.
Joel Swenson: : however there are similar models that do which leads me to believe that your board may be bad.
Joel Swenson: : That error on similair models means F6 E1=Over temp cook, either a bad sensor or board.
Joel Swenson: : You can check the sensor with an ohm meter is should be about 1100 ohms at room temp, if not its bad, if so the board is bad.
Joel Swenson: : You can end the diagnostics.
JustAnswer Customer: Where is it located?
JustAnswer Customer: The sensor?
Joel Swenson: : The temp sensor is the probe you see protruding out of the back of the oven.
Joel Swenson: : back wall inside oven.
JustAnswer Customer: Do you have part #s on those items for this model?
Joel Swenson: : The board you need if the sensor checks out is Range Oven Control Board part number, W11256088.
Joel Swenson: : The sensor is Range Oven Temperature Sensor part number, WPW10181986.
Joel Swenson: : You may find it on ebay or amazon or you can just google that part number and you will find plenty of places to order it from online.
Joel Swenson: : In order to rate the answer you have to use the star rating system.
Joel Swenson: : You must click on one of the empty stars.
Joel Swenson: : The 5th star to the right is the best.
Негізгі бет F6 E1 is the code my whirlpool stove is throwing. Even when
Пікірлер: 3