ハセガワの古いキットで縮尺が1:32と結構な大きさ。 これを今回は折り畳み翼に改造致しました。 最近は折り畳み翼になったキットが出ていませんのでね・・
この折り畳み翼にする為の蝶番の取り付け角度がかなり難しいのです。 今回は前回よりはかなり良くなってはいますが、まだ完全に成功には至って居りません。 折り畳んだ状態を真横から見た場合・・主翼の先端は水平尾翼より上の位置で止まるのが正解。 しかし残念ながら今回は水平尾翼より下になってしまいました。 僅かな蝶番の取り付け角度によってかなり違ってしまいます。 またいつの日か挑戦してみます・・・。
翼端灯・着陸灯・主翼下面ライト2個・機体上部と下部の信号灯などはアクリル材で再現しました。
アメリカ識別マークのみエアーブラシにて描きました。
コックピットにはエッチングパーツを主翼にもエッチングの機銃を使用しました。
キャノピーは開閉可能に・・プロペラは回転します。
This is an old kit from Hasegawa, and the scale is 1:32, which is quite large. This time, we modified it into a folding wing. There aren't any kits with folding wings available these days...
The installation angle of the hinge to make this foldable wing is quite difficult. This time it's much better than last time, but it's not yet a complete success. When viewed from the side in the folded state...the tip of the main wing should stop at a position above the horizontal stabilizer. Unfortunately, this time it was below the horizontal stabilizer. It varies considerably depending on the slight installation angle of the hinge. I'll try it again someday...
Wing tip lights, landing lights, 2 lights on the underside of the main wing, and signal lights on the upper and lower parts of the fuselage are reproduced using acrylic material.
Only the American identification mark was drawn with an airbrush.
Photo-etched parts were used for the cockpit, and photo-etched machine guns were used for the main wings.
The canopy can be opened and closed and the propeller rotates.
Негізгі бет Автокөліктер мен көлік құралдары F6F 5 1 -32 グラマン ヘルキャットャット 折り畳み翼に改造 Converted to folding wings
Пікірлер: 6