Remember that one time that I was going to mock up four tubes to start the day off and then move on to something else, but then it ended up taking all day long? I do.
This is how it goes though. You mess up one measurement, then the tube doesn't sit the way you want. Then you start over, then you go to lunch. Then you get a visitor. Then you play on your phone for a bit. Fabricator problems.
Anyway, I got my four tubes done plus two in the front that only took like 20 minutes.
Also, we have a winner on the T-shirt give away. This was fun, I will do more give aways in the future, stay tuned!
My build thread - locostusa.com/forums/viewtopic...
Hanging The Diff - • Locost Miata Different...
More Rear End - • More Rear End Work! Al...
Rear End 1 - • Check Out My Rear End:...
Welding the Frame - • Weld It Up! Locost Frame
Adding Braces to the Locost - • Brace Yourself: Locost...
Top Tubes - • Top Tubes: Locost Fram...
Bottom Tubes and Upright Tubes - • Going Vertical: Buildi...
Locost Front End Build - • Locost Front End
Starting the frame build - • New Build: Project Locost
Getting the Locost metal - • Lets get sum metal
Z Gone, Locost Introduction - • Back In The Shop: Proj...
IG - @car.sick
FB - @car.sick.show
carsick.bigcartel.com
Негізгі бет Автокөліктер мен көлік құралдары Fabrication Takes Too Long: Locost Support Tubes
Пікірлер: 26